Find experienced local tradies in Sydney Eastern Suburbs

Hand 4 timber shutters on wall outside . Drill into rendered walls .

Painting of verandah ceiling of timber lining boards. I will supply paint. I coat primer, 2 coats gloss. Can be done anyday. 5m x 1.5m

The old awning flew away due to wind. I've purchased a new like-for-like awning. It needs to be installed and screwed into the wall. The wall is a hollow wall, and the previous installer used a sort of filler expansion hard-setting foam to secure the bolt to the wall. This requires a special tool and a special building-grade filler. A successful job will be awarded to quality workmanship who can prevent future wind support issues and deterioration to the wall with no leaks. Existing awnings and supports have been removed, which is not in the photos. Works needs to remove all debris and scraps off site. When do you want to start? I'm flexible on start dates What is the status of your job? Ready to hire What type of service do you require? Replace existing awning What type of awning? Fixed Do you require supply and install? Install Only

Remove peeling render on an internal brick wall. Wall is above staircase and spans two levels. We want all render removed and for the wall to be left exposed as brick

Dent/hole on corner of interior dry wall

Opening a shop in Paddington have ongoing work for right person.

Check the photos Few small part need to get done Pls send your offer $123 is only a number

Scrap back and clean awning prime and paint with exterior paint X 2 Also scrap back and paint side of awning and paint.

Building a new multi story house and I have a substantial quantity of glass balustrades (spigot mounted) to be installed. Will need some posts core drilled and spigots bolted into concrete. Happy to pay by the hour/day/or quote on total job. Can be one or two people. Experience required. I will be on hand to help. Have put an indicative hourly rate in.

A large built in wardrobe in good condition needs to be dismantled and removed from my house. It is modular and 240cm H x 269cm W x 65cm D with 3 mirrored doors.

Need a painter to fix paint signage on a shop / cafe awning. Bondi2026 sign needs to be painted black. The Up South logo needs fresh white paint Previous Airtasker did not show up so need this done ASAP!

I need a renderer with previously experience to go after my bad patchwork on the facade as shown! The widith is about 6M and the height about 4 m at the top with around 50cm around. Also to do the inside trim around the sliding doors. I have purchased the same rockcote two 15l drums so should be plenty

Our awning was ripped down by some pedestrians. Needs to be re-installed.

I need an area of about 6 square metres rendered to match the thickness and finish of the rest of the wall. I'll paint it once rendered, so I just need a good finished coat that I can prime and paint. There's also a few other spots pictured (next to the yellow parts) that need filled in with render.

I currently have a built in wardrobe. The interior needs to be removed ( it is currently bookshelves, a desk and drawers). I would then like an IKEA or Bunnings ready-made shelving unit to go into the carcass. Shelves need to be 40-50 cm wide. Would suit a joiner, carpenter, someone familiar with built in wardrobes and assembling ikea/ Bunnings flat pack things.

Looking for someone to patch rendered brick wall - just areas in red. Need to fill in bottom half of the intercom cut out as shown and the holes in red.

Paint newly installed balustrade on deck. Top part of balustrade needs prep/sanding flat of holes before full painting, see photos.

I have an existing built in wardrobe that only has hanging rails in place. Need someone to supply the melamine shelving and drill the holes to install the little bracket inserts

Install 3x2.5 metre folding awning

Am sanding back the stair case and need to remove the glass balustrade - don’t have the tools to do so. Should take about 10 minutes if someone had the tool to unscrew the brackets.