Find an experienced water features contractor near you

We have 3 water features that need repair - pumps not working.

Mechanical lift of 170kg water feature across a residential swimming pool . Trough base is in situ, upper part of the water feature needs to be lifted and installed in trough base.

The landscaper didn't really futureproof the pool water feature, it rusts and chips of the rusted steel falls out and into the pool. Also, the water drips onto the bluestone pavers so they're rusting underneath the feature too. I just haven't been running it to prevent further damage, but I'd like to be able to. Need a plan and a quote to make the feature a little more rust proof and to prevent dripping on the pavers. If possible, would also like the rust cleaned from the pavers.

Water feature is not working optimally and needs a service to get it working normally.

Gardening and cleaning fountain

Hi I have a small water feature which needs to be emptied and cleaned before December 17th

Non working water feature! Needs new pump

Empty and clean a fountain

Hi, we need to get our water feature cleaned. We don't use it anymore and planning on eventually closing it with pebbles etc. But need it thoroughly drained and cleaned before that.

Overgrown water plants in water feature . Over grown plants need to be pulled out of water fountain

Small paving project (approximately 120cm x 150cm) in our backyard for our water feature to be placed on. Pavers are already in position. However, the ground underneath needs to be worked on so that it's completely level. Then, weed mat and sand will need to be laid under the pavers prior to placing the water feature in position. Pavers and weed mat are supplied by the owner but we'll require the appropriate quantity of sand to be delivered

Need pool water feature tiled , have tiles ready to go

I have a water feature that has a reservoir that’s 4m x 30cm x 30cm. It has leaves on the top as well as dirt and dead leaves on the bottom that’s clogging up the filter. I need the whole reservoir cleaned out really well and the rubbish disposed and the area left cleaned once done. There’s about 2-3cm worth of dirt and crap on the bottom. Job should take 60 mins.

Existing Water Feature needs Stonecladding and Waterblade installed and possible rebuild

I need a water feature reservoir cleaned out. At the moment there’s a layer of leaves (maybe about 4-5cm deep) and dirt that’s sitting on the bottom and it needs to be cleaned up. Can’t leave any dirt behind otherwise it will clog up pump. It’s 4m long x 30cm wide x 30cm deep. All rubbish needs to be removed and the area left very clean once it’s finished. The job should take around 60 mins to do it properly. This needs to be done properly by someone who has attention to detail.

I need the pond and water feature cleaned and refilled. Pls look at the images attached.

Assist me with a very small backyard tidy up, the backyard has 3 small water features/ponds (less than a meter in size) which have become filled with leaves, etc. that need to be cleaned. There are also 3 water fountains that need to be cleaned and one of the water pumps needs to be replaced. I have the new water pump, we need to change that over. This needs to be done today before 4pm.

We are about to have a pool installed and the pool company will provide the plumbing to create a simple waterfall water feature at one end of the pool. Approximately 3m long x 600-800mm high with 2 x 900 mm water blades. It can be tile cladded.

I need my water feature cleaned and the pump serviced. The pump works but the hose is lose and it also needs to be cleaned

Need to empty the water from water feature and high pressure clean the tank and the drive away. Also gutter has to be cleaned.