Find experienced local fencing contractors in Brunswick VIC

timber side passage/garden slat gate needed made and installed. measurement of passage approx. 160cm width. wanting a gate of roughly ~180cm height. nothing crazy just need to keep the dog secure and height for privacy! not really sure about pricing so hit me with your offers :)

Supply and install colorbond fencing and sliding gate. Side fence approximately 4 mts long and sliding gate side approximately 5 mts long.

My wooden fence is missing about a dozen palings. I have bought replacement palings. I need someone with a nail gun to install them. Should only take 15 minutes.

Our fence has been a bit loose for some time, it’s falling a little to the right. We need someone to repost it. Probably about two posts that need reposted.

We need someone to make a steel / wrought iron gate for the front of our house. Please see photo. It will be approx 1.2m high and 1m wide. We don’t have any designs.

As per title and picture Thanks

Existing brick fence repair and modification job

Installation of front emu wire fence. Front yard is approx 7 meters in width. Posts and rails must be checked out correctly and latch to be installed on gate

Hello. We need our wooden pailing fence between our yard and the next door neighbours replaced (approx 9m). We also need our back yard fence which backs onto a right of way replaced approx 5.2m. This section of the fence has a gate which can be reused.

I need a steel gate to mimic my neighbours and run along my existing gate. First few photos are of neighbours fence that needs to be mimicked. Following photos are of my current fence and measurements. Please provide rough quote if you are interested in doing work. Thank you

8 metres of fence where existing posts are loose and boards warped. Side gate needs to meet the fence securely. 4 posts is the likely requirement.

I have a 2004 Subaru Outback with a damaged rear quarter panel on one side. Looking to see what it will cost to have this repaired or replaced.

I need a gate installed pr

I need you to attend on site and modify 4 x 135mm posts I have with the following : 4 x horizontal around the top o fthe post 16 x vertical corner chamfer's see attached pics

Rivets have come out of fence at rear

3m timber support + wood bracket please attach to fence (have the existing wood) to make fence stable

Remove wooden bamboo screening which is attached to aluminum fence. All wooden material to be removed. Discard all of the screening waste. Paint the remaining aluminum fence dark grey

Remove existing side gate and current timber it is attached to on the walls. Install new timber gate and new timber post to attach to wall. Gate provided, timber provided. Will need to provide required screws and any bolts Dispose old gate and timber.

4m brick fence knocked down, 2m old brick barbecue knocked down, 1m x 4.5m of concrete pulled up and removed

Supply and install 4m of 1.2 M Heritage Wire Fencing (white) Existing fence posts/railings to be used to mount to We are not replacing gates at this stage but you can estimate on that later after the first job finished Must take fence palings away / dump