Find a professional chandelier contractor in NSW

Assemble and install a 8+4 chandelier

Location: Schofields, NSW 2762 Need to replace existing chandelier lights on the staircase. You might need a 3m+ ladder or a ladder which has adjustable extension for the stairs. I have already purchased the lights.

Need to install 6 chandeliers (8arm), 2 fans, 4 outdoor wall lights and 1 security light at our home in Austral. Chandeliers and fan points are ready to install, however, cables are to run for outdoor security light. Please consider below while quoting- -Assemble and install 6 chandelier lights and 2 fans -Run cable for 4 outdoor wall lights and 1 security light and install

I have 11 flatpack chandeliers that need assembling, including their stands. Each chandelier is approximately 3 meters tall. They just need to be put together in my garage. only the stands need to be built—the crystals do not need to be attached.

Install 40cm chandelier in the living and 3 pendant lights in the kitchen. Don't want to be cutting the wall or ceiling to run the wires.

Need to install 2 jet black bohemian chandeliers (8arm) at our home in Marsden Park. There are currently a chandelier and a fan in the place where we want these chandeliers to be installed. Please consider below while quoting- -remove existing fan and light -assemble both chandeliers -install 2x 8ARM JB Bohemian chandeliers -assemble gems(globes) for both chandeliers

Have to install the chandelier on the roof

We have a chandelier in the staircase which needs to replaced by smaller modern chandelier

I need 2 lights removed and a chandelier installed.

Looking for person who can assemble a chandelier in Gables NSW. Frame is already installed. Require expert to assemble remaining crystals and left over onto the frame. See pictures for current conditions and final look (first chandelier in the photo). Scaffolding available.

Replacing two ceiling fans and install a large light round Chandelier in a dining room and 2 small light Chandelier over a kitchen island. You need to run the cables and make 2 separate switches 1 for large chandelier and 1 for both small chandeliers - see pictures. The fans you just need to place old with new with remote control. Old vans were operating on remote control. Double story home.

Looking for person who can assemble a chandelier in Gables NSW. hourly $35.

Looking for person who can assemble a chandelier in Gables NSW. hourly $35. Approx 70kg weight

Install metal chandelier. I'll help where required. Should be done in 30 mins.

We need to have one chandelier and three external lights installed. I’ve included pictures of the lights and the locations where they’ll be installed below. All the wiring, light points, and switches are already in place—only the light fittings need to be replaced. We would prefer someone who leaves the space clean after installation and doesn’t create additional holes in the walls (we’ve had this issue before). A licensed electrician is required for this job. We’re flexible with the date and time, as we mostly work from home.

I need to take the ceiling fan out and put a chandelier in

Need someone to Cut gyprock above kitchen island Install timber to support 15kg chandelier Put the gyprock back Patch and Paint

1) I need 2 additional downlight installed in the kitchen. 2) Wire and Install a new Chandelier ( No existing point ) Notes Downlight is supply and install. Lights need to be aligned straight with existing downlight I will supply Chandelier to be installed. Needs a dual on off switch. I dont want to touchup the ceiling paint. So if possible please advice if this can be done without the need to cut additional holes and patch.

Crystals have to be installed into 2 Chandeliers. Frames have been installed already. Scaffolding is already present. Please see pictures.

- 6kg chandelier to be hung from ceiling - a trade told me he’s put a wooden piece in the ceiling to hold the weight. But in the hole in the ceiling I can’t find it. It may or may not need a wood in the roof to hold the weight.