Find an experienced fireplace installation professional near you

2m wall, need a 2m media wall built to fit a 1.2m fireplace. Flush at one corner. Do not need hole for tv but want the spaces on the right as the photo below.

Fitting a flue for a fireplace outdoor corrugated single sheet roof

Flue fitted for fireplace outdoor through corrugated single sheet roof

Single corrugated roof and needs sealing around flue

I would like to make the electric fireplace to look flush with the wall. Ultimately built in with tv and some cabinets for storage under neath. Open to design and other ideas to make it look better and still function safely. These are the measurements. The wall space is: 2 metres wide x 2.5metresHigh x 160mm. Would love it to enclose both items and possibly 3 draws along the bottom so we can get rid of the tv cabinet. (height from bottom of fireplace is 500mm.

Repair the fire place marble which has chipped off. -need experienced person to repair a chip in the quartz stone bench top as well as repair the marble. - Due date: Flexible

Electric Fireplace does not work.. No Light and No Heat.

Aurora Archer IS700 Heater fireplace installation I have currently installed a "Gas Heater - Heat Glo ATS-AU-D" model, which is difficult to find parts for. I bought a second-hand, good-condition "Aurora Archer IS700 fireplace Heater" to replace it. The installation will require creating a power socket in the wall since the current one is all wired within the heater directly to the power supply, and I want to change that.

I need the fire place & stone base moved for new floating floorboards to be installed. I then need the fire place & stone base returned to this position after the floor boards are finished. This would be approx a week later.

Put together the Buschbeck outdoor fireplace/oven - my husband will help physically

Wanting to have this fireplace tiled in a travertine finger tile. which comes in 30cm x 30cm sheets Area is roughly 2sqm Already have the tiles and can get grout and other materials needed if required. Frame of fireplace can be removed for ease if needed.

Patch 2 large holes, paint wooden fireplace surround, hang door on pantry, remove curtain rail, paint and finish. I have paint

Install a suspended gass fire pit from ceiling in lounge room access to roof if needed to make supports to hang rouhgly where existing artwork is in attached photo https://luxefireplaces.com.au/products/aeris-hanging-cocoon-matte-black-with-angled-stainless-steel-suspension

I have a weird fireplace is my house, I'm gonna leave the chimney but I'd like to remove the wider base layer of bricks visible in the photo, I just want to know if they're holding anything up/if there load bearing/ or if I can swing away.

Mount the following 1 tv 65 inch - mount available (2 screws) 1 fireplace - mount available(4 screws) Mount 2 small round mirrors Mount 2 big mirrors

Removal of fire place, chimney and brick footing.

Remove an old free standing fire place and patching the interior roof

Must have experience in removing old chimney from old small house made from old concrete in 1916.

Looking for a brick layer. Need my brick fireplace reskinned (tied from existing bricks all the way around) currently chimney is approximately 1900x700 6800mm ffl. Red recycled will be supplied, will have quick stage scaffolding, walls and roof will be cut back as these are getting rebuilt anyway. Footing will be completed before hand

I need a tradesperson to assist me to assemble a simple flat pack for a wooden fireplace mantle: I've done half of it but it needs finishing. Not sure if I've done it right! Simple job. Likely take 1 hour if you are a tradie!