Book professional blind repair service in West Sussex

There are 8 roller blinds of various sizes to be put up in our office

I had some work done to a window and the person took my blind down and didn't hang it back up right. It's an easy job to re position it back into place correctly.

Landlords have advised there are concrete lintels reinforced with metal rods around window area Venetian blinds to be fitted

Just 2 Venetian blinds to be fitted in my retirement flat .

Repair needed, blind fabric come out of roller.

Source and fit blinds for living room and bathroom. Living room has double doors, 113cm width, 175cm height. Bathroom window is 77cm width, 76cm height.

I have a roll up blind. It winds down but will not wind back up.

One wooden vertical blind needs re stringing due to being in place for 10 years in a room with a smoker, the string has become sticky with nicotine

I have white wood Venetian blinds that I need clean

Need venetian blinds fixing

I need a curtain pole and roller blind mounted. Thank you

Installation of 3 wooden blinds onto bay window.

I need a blind hung. Tricky as doesn’t quite fit

I have two roman blinds that need to be fitted, three shelves to be put up and a clothes rail to be fitted in a cupboard.

Put up new curtains and blinds Install blinds tracks etc..

Two rollar blinds fitted They will need cutting to size

Install 3 blinds (two slatted, one Roman) Previous fittings to be removed first too - rusted over so is a bit tricky

Roman blinds need re stringing

I have 3 sets of blinds that need 3.5cm sawing off each end including the metal headrail. A power tool might be needed.

The blind has tapes to make it look like shutters, 3 of the 5 have come apart at the top. The blind needs taking down, the tapes re-threaded and fixed together. I have done this myself on smaller blinds but this is quite a large blind and too heavy for me to do. The pelmet over the front of the blind needs removing first, the installer has put some filler on the top edge to neaten it but this will need a blade to run along it to release the pelmet first.