Find a trusted local electrician in Cheadle Heath

office light repair, the lights flicker even if the bulbs are changed

I need the bearings on my washing machine changing please

We need a Pax wardrobe combination building, corner unit also. Measurements - 100x58x236 Corner unit - 53x58x236 Smaller wardrobe - 75x36x236

Mould across 3 areas of the fitted wardrobe that is to be cleaned and rectified

We are having trouble with bidet shower installation.

Assemble wardrobe please…

there was damp coming in from the outside because of the faulty guttering and a gap in the seal where the building is joint. I've attached photos of the outside for your reference. There was damp on the carpet too which has now been removed. The building management company is sending contractors who are sorting out the outside they’re going to replace the gutter pipe and paint the wall with a rubber paint so the whole wall is sealed from the outside. So I need a quote for the below: Removing the bottom part of the wall because it's damp (approx. 30-40cm from the floor up), drying it all out and damp sealing from the inside, putting in a new wall back up.

Multi functional smith machine

55 inch Toshiba TV screen not working, vertical lines showing and a slight display at the sides of the screen

I made renovation to my driveway with Tramac as you can see in the pictures. As they laid new layers on the ground the tramac level went up and made the gate unable to open inside as it used to be. Need it fixed to open inside. Need free no obligation quote please. Thanks

New kitchen table extending from Danetti. The legs need putting on the upper part. Tot weight 90 kg. Two man job. The first picture is of the box holding the legs. The second photo is of the table propped against the kitchen wall.

Install a Eufy E340 doorbell on preexisting wired system

https://www.amazon.co.uk/dp/B0C38VYM4Z?ref=ppx_yo2ov_dt_b_fed_asin_title Click on the link above to see the light.

Bought a second hand Reebok GT40s Treadmill but it's not working and needs repair as getting an E7 error when powered on (when the safety key has been inserted). Think it might be a wiring issue as can see evidence of wires being taped together from main board to control display unit rather than via a connector as per user manual.

We are finishing off a bathroom install and have been let down by joiner. Need to box in the toilet and sink, leaving access to the TMV for the sink (either with a hatch or removal screw panel). Also want to replace trims around windows as not neat and edges need to be rounded off. Needs doing this afternoon ideally.

Sliding door wardrobe, one door come off and can’t fit back on

need to setup a ring camera on front side of house

Pipe work is boxed up, require access to the pipes for the boiler man to work. Can provide photo to clarify task

Painting walls snd ceiling and gloss woodwork - Due date: Flexible

need to set up my 2 door wardrobe - Due date: Asap