Find a local electronics repairer in Surrey

My vanity unit (picture attached) needs replacing. I purchased a like new unit, more or less the same except basic non fancy taps! I will try and upload a pic of the new vanity but it's essentially the same thing with normal single hole tap..The newer unit was sold to me already put together with basin, taps, flexor pipes already attached so there's no work to be done in putting the cabinet together or adding a basin. Not sure but someone said yeh flexor pipes might be short on the replacement vanity so I will buy some in case needed. Thank you

Small kitchen, someone to wrap all kitchen cupboard doors and worktop. 11 small cupboards and 6 drawers and worktop. We will provide the vinyl. Handles for doors will be already painted so just the doors and worktop will need doing.

Stick drift repair on ps5 controller (soldering required)

A wire needs to be sold to one of the electric motors on my tiny whoop drone

Wide plate ghd straighteners just outside of warranty have started flashing red and not heating up.

Sanding the stairs filling the gaps with filler and painting the sides

2 LED strips DLR amd turning signal to be installed

Vw Up 2012 i want to in stall a pioneer gm-d1004 amplifier and two piece component speakers. I have all the kit, deadening, foam rings and harness

Double mirrored wardrobe - 6 boxes (heavy)

Need someone to complete the last 2 drops of wall paper and cut in one wall at the ceilings.

Clean, prepare and paint a front driveway five bar gate and two sets of wooden steps.

Sharps bedroom door (full length) has come off its hinges and need resiting. Small job but needs to be done.

Build a 3m shuffleboard table

We’ve just bought a house and the hot tap for the bathroom sink is broken, the previous owner managed to flip the isolator valve to stop hot water flow, but they’ve rounded the screw head (can’t get it back on). We’ve bought new taps, and have new isolator valves (if needed), but need someone with experience to fit them (the new taps and potentially the new isolator valve on hot side).

To fit new laminate worktops that will be supplied. U-shape 1.4m x 3m x 1.4m approx Existing worktops will be removed prior to the installation

Our fridge is cool but not cold and won’t get cold. The loft door keeps swinging open. I think the clasp is broken

need to either repair or replace lead flshing under bedroom window

The machine is currently very unreliable. Usually 1 in 3 coffees is drinkable. It seems like the ground coffee doesn’t always end up in percolator.

HDMI port is broken and needs replacement

We have 7 wireless access points ( all Draytek). 2 of them intermittently stop working. They could be fine for 6 or 12 months and then stop working. After a day or 2 they usually start working again but not always. The other Draytek WAPs in the house never cause any problems - it is always the same 2. There is also an external WAP which is intermittent