Find a quick reliable mobile welding service in London

I have a broken footstool and a bed slack that need reparing

Hello! One of the legs of my metallic table had broken off. I would like it to be welded or otherwise fixed. Please let me know if you can help.

Welding work - to welding broken metal rods of a bunk bed

I need someone to weld a bed frame that started to crack. The crack is about 5cm long as can be seen in the picture

Toyota Yaris 2012 Automatic bumper Repair by Plastic welding,.

Repairing a broken dining chair leg

A metal part under the running track has broken and needs welding, it’s stopping the running machine from fully going down and making the track go to one side

Previous welding of a jembe drum stand has come apart and needs welding back together.

I have an L322 Range Rover 2004, with the rear wheel arches and end of the box sections are rusted and need replacing. It's a common fault with this car, and parts are available. It is an MOT failure. The side sill covers are off so I can now see the issues, see the pictures. It will also need spraying to match the wheel arches, but the box sections need painting to protect it as it's not seen normally behind a plastic cover. The paint can come later, but ideally done at the same time, not vital.

We need someone who has a welding machine to attach a new set of wheel with cast iron clamp. As the main part of the wheel iron is welded, we cannot attach a new one without a welding machine. Please get in touch

Need same one with skill experience and equipment to do electrofusion welding.

Need a small piece of a metal gate welded together

The metal rods that holds my sofa up from underneath has snapped and requires welding back together.

Water supply lead pipe is broken at ground level. To mend, need to insert in 15mm copper pipe and solder it. The 15mm pipe goes into lead pipe by about 2cm. There is more plumbing work if the welding works.

I’m looking for a qualified welder to do 4 cuts somewhere so I can get this into my house! It’s slightly too tall to go through the door! It will then need safely welding back together inside. Please quote!!

2" impact hole osf chassis. Car too low slung to weld using jack or my flatmate would have done it. Daihatsu Materia. Need ramps of some sort.

I need a supporting bar on our pushchair welded together, if possible. Normally I would have thrown the pushchair away, but we have all of the ancillary bits which attach to it. They don't sell replacement frames, so it needs to be repaired.

Need a welder to put the top of my coffee table back together

Small metal squares of various sizes that need to be welded together at the corners. Photograph will make this clear.

Welding in 2 places, please see pic and video