Find professional window and door services in London Fulham

Cord hung sash window (154x97cm dimension based on inner box frame) needs replacement of side vertical beads with draft proof brush (brush worn out). The left bead is broken in two. The right is worn out so both need replacement.

Carpenter / handyman needed to mount cupboard doors (holes not yet drilled)

1 door hung (hinge holes already) 1 door hung (no hinge holes)

To securely drill a Ring doorbell in the wall of a residential property

In order to comply with fire safety, the front door needs to be fitted with expansion seals. To do this the door will need to be planed down in parts

Broken MDF wardrobe door, needs repairing or replacing.

Cupboard door has fallen off wall. Needs to be screwed back in. Screws have gone blunt so will need to be replaced.

We have this electric phone thing for when someone wants to enter the building from the ground floor. They call our flat number and it lets them in. This device has been here forever, has stopped working and is an eyesore. Looking for someone to replace the device & install something simple, clean and modern.

Buying a place with an old back door that needs repair and showing signs of rot. I need some quotes for a repair to be done end of Feb/March

Looking for a reliable and tidy handyman to hang 2x mirrors and 2x mini shelves in our nursery and also to fix a broken bathroom cupboard door. Looking for someone ideally on Thursday but if not Friday between the hours of 9-4pm. I've attached a photo of the cupboard door and for the nursery, to note it is freshly decorated and so we're looking for someone that will be careful with the paint and create minimum mess. Please bring own tools (shelves have their own nails for hanging but we require nails etc for mirrors and cupboard door). Based in Fulham. Thank you.

I got a lid blocking the sink’s pipe. I need to unblock it. Also, the window’s handle is locked in the wrong way and I can’t close the window anymore.

1) Our Doorbell outside is working but no noise is playing inside the flat. Please could you fix? 2) One dimmer switch in our kitchen is not turning the lights on. Please could you fix? 3) a bracket has come loose on the head of one of our lamps. Would you have the right size screws to put it back in place?

1) Door Please supply and install one internal FD30 fire door and closer. This is a new door so hinges needed plus any work to make door fit frame. See spec below and attached photos. Door must open into corridor (towards photographer) against wall on right. Door Spec: A new half-hour fire resisting door-set that meets British Standard 476, Parts 22, and 31.1 to the living room. The door to be fitted in accordance with BS 8214. Provide and fit a suitable self- closing mechanism, together with intumescent fire seals and flexible cold smoke seals. If separate intumescent and smoke seals are fitted the intumescent fire seal must be fitted to the risk side of the smoke seal. Intumescent seals may be fitted to either the door or the frame but must not be fitted within door stops. Door to frame clearances shall not exceed 3mm at the sides and head of the door and 8mm at the foot. 2) Alarms Supply and install 3 x mains powered smoke alarms and 1 x mains powered heat alarm. All interconnected via radio. Spec as below: Alarms Spec: A system complying fully with BS 5839: Parts 1 and 6 (latest editions) for a Grade D system, with LD3 coverage as follows: - Interlinked, mains-wired smoke alarms with integral battery back-up located in the escape route at each floor level - Additional interlinked heat alarm with integral battery back-up located in the kitchen - Additional interlinked smoke alarm with integral battery back-up located in any communal lounge On Completion: The installer is to provide a certificate of installation and commissioning and log book to the user in accordance with BS 5839 : Part 6. latest edition A copy of the certificate of installation and commissioning is required.

Install my ring doorbell - as in attach it to the front of my house. Should only take a few minutes but my drill is broken

3 issues: 1. Sliding doors of wardrobe broken a. Bracket ripped out of wood b. Likely all screws needed still present 2. Bifold shower door broken a. Disconnected at top hinge b. Missing parts needed (rollers) 3. Readjusting of wooden floorings that is spreading open Photos available on request Please text/whatsapp message if phone not answered

3 issues: 1. Sliding doors of wardrobe broken a. Bracket ripped out of wood b. Likely all screws needed still present 2. Bifold shower door broken a. Disconnected at top hinge b. Missing parts needed (rollers) 3. Readjusting of wooden floorings that is spreading open Photos available on request Please text/whatsapp message if phone not answered

3 issues: 1. Sliding doors of wardrobe broken a. Bracket ripped out of wood b. Likely all screws needed still present 2. Bifold shower door broken a. Disconnected at top hinge b. Missing parts needed (rollers) 3. Readjusting of wooden floorings that is spreading open Photos available on request Please text/whatsapp message if phone not answered

3 issues: 1. Sliding doors of wardrobe broken a. Bracket ripped out of wood b. Likely all screws needed still present 2. Bifold shower door broken a. Disconnected at top hinge b. Missing parts needed (rollers) 3. Readjusting of wooden floorings that is spreading open Photos available on request Please text/whatsapp message if phone not answered

Put an external wall socket (provided) by the entrance door, images provided below, videos available

Remove current Cat Mate and install a new one in its place.