Find an experienced builder in Murrumbeena

I need a shed built that I have purchased from Easyshed. Dimensions are approx 3.6m L x 2.6m W x 2.7m H. Steel frame, Colorbond exterior, rear single door, front roller door. Includes all fixings and flashings. I have all engineering plans that I can share over email (they are PDF) that detail every fixing point, etc. Will be built in between fence and house wall and fixed to existing concrete slab driveway. May require slight adjustment to steel column bracket footings to ensure structure is level (driveway will have very slight run-off for water drainage). Air conditioner (pictured) has already been removed. Installer MUST have experience installing steel-framed sheds (this is not a general handyman task).

Looking for a qualified carpenter to: - Remove existing wooden pergola - Build new pergola to replace old one - Paint pergola - Seal and waterproof connections to cladding and balcony Details: pergola has 10 beams is about 6m wide, 1.7m deep and > 2.3 m tall - Due date: Flexible

we currently have no gate and a brick wall. Need the brick wall to be knocked back to make room for a wider driveway entrance and install an automatic sliding wrought iron gate - Due date: Flexible

Will need a new part as pictured in photo so gate can slot back in and move freely - Due date: Needs to be done on Thursday, 10 August 2023

Bauxite will be added to the mix we will match the original finish. Two (2) concrete squares will be poured approximately 2.55m X 2.88m and the second being 2.50m X 2.88m Replace brick trim and save as many as possible. You must have IG and references.

Remove existing veranda and build new timber veranda as per plans - Due date: Flexible

Install timber hardwood post for existing Pergola. The timber size is 3M high and 90mm*90mm. - Due date: Before Friday, 3 June 2022

3m x 1.5m shed from bunnings

I need someone to remove the pergola cover plastic sheeting only - must be fully insured (will need proof) and have experience doing this. See photos

Driveway Repair Have a piece of concrete that has raised up. Need to dig out underneath it so the concrete will sit flat Flyscreen Need to replace the flywire screen and the small hooks that secure it to the window Remote Control Garage Door (Optional) Also looking for someone who can sync the garage door to the remotes - Due date: Flexible

We need to submit plans to Melbourne Water for the demolition of a 2 metre high fence and its replacement with two 90 cm high fence. There is a storm water drain nearby, hence Melbourne Water’s involvement.

Haz, please let me know I you can do that job for me and remove that chimney. I will also need some tiling work done Regards Vito

Demolition of chimney Measuring 2 x 1m, ceiling height is roughly 8ft Needs to be done this week Easy access for removal

Need a daily rate to do various jobs

Two Stratco Saver Handi-mate zinc / alluminium sheds require assembly on concrete slabs in Murrumbeena 1.86m wide x 1.55m deep x 1.90m high

We would like our new Easy Shed (3x3m) assembled

I would like to build an attached open pergola on the side of my house, 3m x 6m - I have attached an example, would like a simple open design with one way slats - would like the roof angled so it is higher on the side that attaches to the house, lower next to our neighbours fence - the area is concreted so posts will need to be bolted - happy to use treated pine as it will be painted Please quote for labour only, have estimated this will be a 2 day task. We can either reimburse you for materials or can have what you need delivered from Bunnings. My parter will be available to help with labour first week of Jan or on weekends. Looking to get this done sometime in Jan, flexible with days and times.