Find an experienced builder in North West Perth

Requiring someone or possibly more than a one person effort to move four heavy boxes from the garage to the rear and build an aluminium pergola with retractable manual louvre roof. Instructions all included within the boxes however I feel this is a good 3/4/5 hour task dependant on 1 or 2 person and their skills and toolset. Must be carefully bolted down and drilled into honed concrete. Each post has four holes to be drilled (16 in total to hold it down) Requires the correct tools/ drill pieces to get through the concrete…. This isn’t a hope and gamble task - I require someone who is more than capable and can do the appropriate concrete tool drilling. 3m x 4m Pergola with 2.5m height

remove and replace the drain grate at the bottom of the driveway

Need to knock down existing mailbox and rebuild. needs to be slightly smaller, with cement border and waterproofed. 1m high, 60cm wide, 78 cm deep. Need rendering also

Concrete driveway approx 10mtrs x 4mtres

I would like tile some additional sections on the wall in my new build. In my ensuite, half wall tile to be continued behind the door - approx 1m. In the bathroom, tiling to continue from the top of the shower to the roof. Spare tiles from the build supplied - will need to confirm there is enough and grout is Magellan grey so grout will need to match.

Stud wall creation Large Bedroom - creating room separation + partition Floor to ceiling. Visit first to quote. thankyou

Areas of my cobblestone driveway have had the cobbles dislodged from vehicle movements and/or have sunk from water drainage. Area 1: Approximately 2.5m x 2.0 m (dislodged) Area 2: Approx 1m x 1m Area 3: Approx 0.5 m x 0.5m They will need to be reset in place so that they are level & compacted and then locked in place. I have previously tried using Pavelock, but it was useless. Perhaps a mixture of Pavelock and ready-set cement.

Needing a shed assembled and installed.

Need to install new shed in Mindarie, on a paved area. Dimensions in the picture.

Require assembly of Shadestyle Gazebo 300 x 400cm Rectangular and side sliding blinds, just bought from Harvey Norman.

I need garden shed assembly

Need to lift bricks to repave as gaps have formed. Use existing bricks. After repaving concrete border to keep in place.

Drafting plans for a front fence and letterbox. I have a rough design i did in fusion 360 and i have the original building plans, just needs to be done up so i can submit a building permit application The pillar/pier height is 1.3m and the top of the solid wall height is 0.75m

Supply and Install a 3.6 metre sheet of Suntuf Opal Polycarbonate roof sheeting to a pitched roof Pergola.

Hey, looking for someone to replace the sheeting on my patio roof, using poly Suntuf Corrugated in Standard Colours, 760mm cover, 9 sheets at 3600mm, supplied and installed.

We will provide the wheel barrow and shovel, need to move this sand into the skip bin at the front of our house asap.

Help putting together a shed. We have purchased a new small 1.5x 2 shed which gets delivered flat packed.

Hi I need someone who can put shading up around small pergola area in back of unit easy job will take around 15 minutes to half hour if you know what you are doing.just need Stanley knife to cut length and tools to attach wood to brick wall and wood pergola/fence.not too finicky I'm on pension and ndis so looking to keep it within my budget but can negotiate a little on price need it done asap please Thanks 👍

We’ve installed the panels and door for our Easyshed 1.5mx3mx2.1 Skillion roof. Just need someone or someone’s to assemble the 4x shed panels and roof together, then fix to the concrete slab. It’s located behind a larger shed so 2x people may be required to assemble on the grass then move into the location as it’s between an existing shed and boundary fence

I have a 1.5M X 5.2M X 2M shed that I bought through Bunnings. It is a 'buildashed.com.au'. It is flat backed and needs to be assembled. Pictures attached.