Find experienced local carpenters in Ashfield NSW

1. Remove and dispose existing timber/acrylic structure 2. Replace and stain up to six decking slats

Wooden coffee table top needs to be replaced or fixed (has lots of bubbling on veneer)

I have French doors badly damaged by my late dog. Needs someone to use wood putty to remould back the shape of the doors and fill in holes where there were screws. One screw is stuck in there so need that taken out. I have the putty..see pics but if you have a better product then let me know the full price including that and any other materials. Painting (at least with primer) would be a bonus so please confirm if that can be included.

Timber table and bench seats requires like sanding to bring it back to a consistent smooth finish throughout. I will provide Vanish for finish. Prefer is this is done before xmas if possible

Looking for someone to install 2 cat doors in the wooden part of my balcony doors. My dad did one room [pic for reference]. Job will entail cutting the wood and installing the cat doors [which I have]. BYO tools. Please send me your quotes!

I'm looking to replace my kitchen benchtop, either using a Ikea Saljan worktop or Acacia timber (which I will treat) https://www.ikea.com/au/en/p/saeljan-worktop-oak-effect-laminate-60439210/ https://www.bunnings.com.au/practa-2200-x-600-x-26mm-acacia-timber-benchtop_p0216266 Approx measurements with current joinery are: Left - 187cm W x 49.5cm deep Centre - 211 W x 59.5cm deep Right - 145 W x 59.5 cm deep Two cutouts required, one in the centre piece for a sink, one on the right piece for the ceramic stovetop. Will also require caulking. In addition, I am looking to have a space in the cupboard to the left of the sink cut out to fit a 45cm wide built-under dishwasher. https://www.bosch-home.com.au/productlist/dishwashing/underbench-dishwashers/dishwasher-45-cm-wide/SPU6IMS01A#/

- we are replacing our kitchen bench top and want to install a butlers sink. - our bench top dimensions will remain the same. - the butlers sink will weigh approximately 35kgs. - we will also need updated smaller cabinet doors to go under the sink. We are hoping to have this all done by 20 September 2024. Looking for quotes atm to get an idea of what is involved.

Build and install a timber air condition cover for the external unit on my balcony. Dimensions are (WxHxD) 1000x1000x500mm. The timber should have some outdoor coating and be painted in a rusty-red colour to somewhat blend in with the red bricks and pipe cover as seen on the photo. The top should have some space to place a small plant pot. It should resemble something like the second photo attached (except for colour) Ideally, please come past (Ashfield) and take your own measurements to ensure the cover fits well around pipe covers on the right. Material to be provided by AirTasker. Budget flexible but to be agreed beforehand.

Carpenter or handy person to attach batons and villaboard wall + gyprock/cornice ceiling to small 2.5sqm bathroom. We will supply materials.

I'm looking for someone who can adjust my kitchen cabinets in order to fit in a single drawer Fisher and Paykel dishwasher. I was thinking of doing this by having someone pull out the inner carcass of the stack of drawers next to my sink as the dishwasher is too wide to put within the inner carcass (see pictures). I still need the stack of drawers for cutlery etc, so I want this inner carcass to be swapped with the one that currently housed my microwave; so the carcass of the microwave area will have to be pulled out in order to accommodate this. I have added images showing my sink area and the microwave area, the type of dishwasher I have purchased and also what the final dishwasher set up will hopefully look like with a single drawer such as the one currently under the microwave underneath the dishwasher. I have already taken off the kickboards. There is nowhere else that can possibly fit the dishwasher as there is not enough space under the sink and every other cabinet is too far from water supply.

I need a carpenter or experienced wood making enthusiast to replace current melamine wall cabinet in bathroom with wood version. I have a custom mirror to go on front, so I want a door that hinges on outside so mirror can be attached fully to front to hide cabinet.

We are looking for a cabinet maker to make a cabinet for our tv and tv lift. The tv will be approx 65-75 inches. Ideally something like this video: https://m.youtube.com/watch?v=xs5hr5oT1LU

Hi we are looking for joiner or carpenter on casual basis for ongoing jobs to install WPC wall cladding panels in residential or commercial jobs Must have your own tools and have experience for installing this kind of panels We provide the material and give you details Pay would be based on the job and how much work is involved

I accidentally scratched my floor moving furniture.. if someone could please help sand and fix this - Due date: Flexible

Need to cut two openings on a wooden shelf , see photo - Due date: Flexible

The wood was damaged with a reddish oil & the whole cabinet needs stained so colour is even - Due date: Flexible

We need someone to modify one top kitchen cabinet to fit the fridge.shorten the cabinet 15cm. Plese see photos. Please make sure not to destory the others cabinets.

In order to replace our hot water system, the shelf was removed and destroyed. We have a new shelf and need it to be affected. Can youIn order to replace our hot water system, the shelf was removed and destroyed. We have a new shelf and need it to be affected. Can you do it please contact me - Due date: Flexible

There’s a stain on the countertop that I need removed i tried a few things and have been unsuccessful - Due date: Needs to be done on Wednesday, 18 October 2023

Setting up a pre-built Melwood shed, dimensions 5.4m by 2.6m, will require small amount of concrete for base to steady legs. Company (Melwood) said approx half day of work. - Due date: Needs to be done on Monday, 11 September 2023