Find experienced local carpenters in Marrickville

Our kitchen cabinets are high and deep making them awkward to organise and access. We'd like to add additional shelves to them to make them more useful. We’d also like to add more shelves in our wardrobes if possible too. Flexible on budget, I understand material and labour costs will vary. For the kitchen cabinets - looking at adding a shelf to the lower section to split it out a bit Main bedroom - adding shelves next to where the little flat pack one is now Bedroom 2 - add shelves where the vacuum is currently with enough space for the vacuum to go next to it if possible. Open to any suggestions and ideas :)

stain deck and top of deck seats the deck (including 2 seats) is 2.7 meters x 3.5 meters (I have about a third of a can of Cabot’s stain) replace 1 small ikea shelf with a new one Replace 6 ikea shelf brackets Touch up paint on 2 door frames Fix bedroom door handle so it closes properly

I have 5 stained glass windows with smallish clear glass panels. I need these clear panels exchanged for opaque glass panels. I can supply the opaque glass but you'll need to cut and install it. Only artisans with experience in stained glass/lead light need apply.

Just bought a shelf has to be drilled into the fridge , screws are supplied just need drill and experience.

Supply and install new timber handrail for internal staircase in townhouse. Estimated total combined length is 5.5m.

Need to repair my wood table top due to burnt

Need a timber fusebox built and installed on an outside brick wall 1020 x 660 x 100

Replace outdoor timber decking. Deck frame ok. Timber decking needs to be replaced as they are weathered and old. 3.2m x 4.83m. Current timber slats 90mm wide. Circa 140 linear metres (taking into account the curved shape of the deck) Small step also needs new timber. Open to timber suggestions. Uncovered deck that gets about 6hrs sunlight a day. Budget depends on timber? Open to negotiation.

I have a custom built hanger that I need drilled together. I've pulled it apart and put back together many times, it's not super tricky. I'd also love to get a table top sanded back. It's roughly 1.8m x 0.7m. Love a quote for hanger assembly only and both together if possible. Thank you!

I have kitchen cabinetry which I’m looking to reorganise to facilitate installation of dishwasher (standard 60cm wide etc.). Not sure if this is built in or free standing as yet. It also needs to be installed under Caesar-stone bench top.

We have a series of bad scratches in our floor and have an inspection tomorrow morning at 9am. Need these covered, dont seem too deep. PRICE IS FLEXIBLE THIS NEEDS TO BE FINISHED ASAP

Have a beautiful (expensive) recycled wood table that’s currently bar height 90cm. We want to remove 5cm from each of the 4 legs to make it dining height (it had casters which has already taken around 10cm off too). Must be done by someone confident and with experience only. We have one shot and the table is very expensive $$$ so need it done professionally. I don’t want to end up with a wonky table!! You will need to sand and seal legs after reducing height. See image. Thanks

I bought a Bosch dish washer to go into my ikea cabinet, and I need some help installing it. I think that it needs to be raised up from the bottom so that the pull door will work properly, but I have no idea, I was hoping you might have some time to come and take a look and see if you can figure it out for me!

Hi, We need: - Removal of 1 x large disconnected aircon vent in hallway. Seal and plaster - Several adjustments to kitchen cabinet to fit dishwasher - cabinet work only. Bench top will remain as is. - Remove old shaving cabinet and replace with new in bathroom - Remove and patch random steel frame in bathroom - Disassemble 3 x freestanding wardrobes $ is arbitrary. Please quote for all works Thanks

A small area of the bottom panel of our in built cabinet has broken off. We would like to return it as close as possible to its original condition in a cost effective way. Will consider recommendations on how to do this - which might include refixing the area that broke off, replacing the bottom panel or something else altogether

Need labour to build up wood counter bar Excluding install We install by ourself just build it up similar of this wood counter bar (green in the picture) High 106cm Long 200cm Depth 85 cm

We are trying to create a home office in the kitchen and need to cut away some of the cupboard support to make space for a chair

I need someone with carpentry experience to work with me and my team on a job in Marrickville next week We are setting up formwork for a concrete screed Very basic carpentry skills required

Timber shop shelves to be built in Marrickville

Cut part of a shelf inside a kitchen cabinet in a flushed manner. I have included a photo with drawn lines on how the shelf should be cut off from the cabinet.