Find experienced local carpenters in Sydney

I would like to build two door inside my place, first one, H 2000 W 800 Second one is H 2000 W 900

Cut access panels in the ceiling of wardrobes to access ducted aircon units.

I’m looking to replace my kitchen benchtop. Task includes removing the current one, cutting a new one (most likely a Caesarstone)to size and installing it. Please provide an estimate quote and timeframe for completion. Photos of previous similar work would be appreciated. Left: 270x60cm Right: 177x60cm

Builder requires additional carpenter to assist with new spotted gum decking installation Must have own tools, countersink bits, etc and a great attitude. Hourly cash rate shown

Cut and install skirting to 3 flights of stair (16 steps each). Skirting on one side only for 2 flights. Skirting to both sides for 1 flight. Skirting to match 110x18 skirting. Painting excluded.

We need wardrobe installer for hi-rise construction sites. We deliver the material on the level. White card is essential.

2 White shelves to be built at the bottom of space that is approximately 120 wide, 45 deep (see picture attached). I have not purchased shelving.

Offer to supply and fit latch to timber door. - View all the details of this offer: https://www.airtasker.com/offers/01JESCGCD5PK777CG745JC5NJE

Remove current bench top and install new ikea laminate bench top, sink, tap and induction stove - all supplied. The bench top is 3.75m

Hallway draw requires building- last Airtasker cancelled. Hoping for today.

Labour wed 8h Labour thurs 9h - View all the details of this offer: https://www.airtasker.com/offers/01JDT83AYJE4XXF0TMDNW9KN0V

I need a the supply and installation of four angles for columns, each 2700mm in height. Only four angles are required. We will handle the sanding after you set, so your quote should cover supply and installation only and setting. It’s a job that should only take a few hours.

*reposting* Hi there! Have a property in Waterloo that is a dance studio. We are doing some renovations and replacing some walls with some removable walls. I have drawings made of the changes but the company require CAD drawings with accurate measurements of the room to be able to provide the removable / partition walls. Additionally - we are putting in a small kitchen and also require accurate measurements of the area. The space is approx 100 sq.m that require the drawings and the kitchen area is approx 15 sq.M. Hoping someone might be available today or tomorrow. Please advise days and times available in offer, as I have to match up with when the space isn’t currently being used. Drawings and information —> https://www.dropbox.com/scl/fo/st3ng9gxsvu6fu10a83x1/AKJt70H7OphtxOUVMMXecAc?rlkey=mma038lo2ocsr08bmjiz13z42&st=fqe7v9wf&dl=0

Build freedom table today details below Table top has arrived in wooden box that needs to be opened KEY FEATURES Engineered wood and ash veneer slats Terrazo stone top Table Top Thickness: 5cm Leg Height: 74cm Weight Capacity: 100kg Colour: White Size: 120cm Material Composition: Engineered Wood, Ash Wood, Terrazo Stone Web Size: 4 Seater Product Code: 13123831 Assembled Product Dimensions Width: 120 cm Depth: 120 cm Height: 76 cm Weight: 55 kg This product consists of 2 boxes or components Box / Component 1: Width: 130 cm Depth: 130 cm Height: 7 cm Weight: 66.7 kg Box / Component 2: Width: 65 cm Depth: 65 cm Height: 77 cm Weight: 23.5 kg Assembly Quick Assembly

I am looking for a plasterer to reseal a bulkhead that was opened to install new Air conditioning . This request is for the supply installation of the plaster ready for me to paint. The space is 10 m long and half a metre wide. 5 m² in total.

I have two cat hexagons that need to be assembled and installed, and three cat shelves (steps) that need to be installed. Advice about placement on the wall most welcome! **Hexagons** Height: 36 cm Length (between the furthest ends on the front panel): 41 cm Width (depth, distance from wall to front panel): 28 cm **Steps** 18 cm wide, 19 cm These are being installed into gyprock/drywall. All hardware, screws, anchors have been provided by the person who made these specifically for drywall. Photos of the hexagons/steps are from the website of the person who made them for me. Thank you :)

When I had new floors installed, the builders shaved off the bottom of my bedroom door. It is rough. I’d like someone to add a slim (<.25 cm) panel of wood to seal the bottom. I have an empty parking space you could use to do the work. There is plenty of street parking nearby during the day.

This fee is for a site inspection only. I need a carpenter to cut and fit some wooden wall mouldings to one large room, one small room and an entrance foyer in my apartment (floor plan attached). I have attached details of a similar job completed for our neighbour for reference. I have sourced the type of profile we would like (pic attached) but anything similar would work. The successful carpenter will need to attend to do a full measure and quote but I estimate it’s a two day job. The job must be completed on Friday 17 and Saturday 18 January as we have a painter arriving on Monday 20 January. The job is in Elizabeth Bay. We have off street parking for two cars. The price needs to include all materials.

We are relocating our restaurant to a new site. We have salvaged our wooden bench tops and would like them cut and fitted in the new place. Only have screenshots from a video but can get better pictures sent / give access. Benches to be built on 2 walls.

Install 2x IKEA LACKS Shelves (190cm) on drywall. The person needs to find the studs to ensure it’s safe to hold books.