Find an experienced door installer in Inner South West Sydney

1 door of built in wardrobe came off needs someone to put it back properly.

I need this door replaced asap

- Replace handle and lock on glass sliding door - fix security door (currently it comes off the tracks) - replace lock and handle of security sliding door (I have already purchased this)

Replace the door. It's bent and does not close properly.

I want to install a metal door to my backyard He may cut the door from the fence and make a door , but need to bring a post and key lock

Install one standard size door at my property

Build 2.5m long x 2.4m high steel stud plasterboard wall. Sheet, set and paint. Square set to ceiling. Supply and install door.

replace 3 door and paint,

I need an old door taken off, and new front door installed. The new door needs a new lock installed so will need measuring, cutting and then attached with anew handle.

Fix hole in security door or replace door. Door is 89cm x 207cm

Installing bunnings doors in the hallway, bathroom doors, cabinet, ensuite and outdoor laundry doors. Approximately 9 doora in total

Need someone to supply and install a solid door . I have the security handle .

Need door replaced with new doors. Materials are supplied - two panels for front door, one panel for back door. Front doors, will need new drilling below door, and into the ground since the one panel is large, and one is small. Preference is to do Additional work for Additional cost: Aqara smartlocks Painting doors (front door yellow, back door white) See I've added images of bolts and hinges. Two bolts and nine hinges (3 for each door panel) Note these are solid (heavy) doors and location is Bankstown

Install a door jamb, door and door handle for a bathroom. Architraves required on both sides. Job is in Lakemba. Single story house. Door size 2070 x 760. Please send me quotes to review. Old door door jamb and architrave already removed.

I would like some shelfing for a pantry as well as a door installed. The dimensions of the pantry cavity are H.239 W.73 D108. Second photo is what I would like the shelfing to look like.

need to install new door, and lock .

Currently the room entrance is 125cm wide by 212cm high without door. I want to install a door with standard frame of around 90cm x 210cm. Therefore, the drywall needs to be extended around 30cm on one side.

The lock for the sliding glass door stopped working. I think you need a new door handle/lock. Because the existing one does not work and too old. I have been unable to get a replacement. Will pay for parts as well on top of labour. But need it fixed ASAP

I have a door that needs about 70mm trimmed and reinstalled.

Need a chippie for a few hours, to do: - wall mount a large mirror & 2 paintings - wall mount a dryer - install approx 10 door stops - wall mount a drying rack & a hook rack Walls are gyprock.