Find an experienced driveway repair contractor in Inner South Melbourne

A delivery truck has scraped the pillar/wall at the entrance of our driveway as it was leaving. I believe there's a thin layer of concrete that has been scraped away and thus require a new render to fix. Also need to be repainted. Please provide a quote.

My driveway has two spots where the pavers have sunk. Both around 75cm across. One of them is quite deep around an inch or two, the other is very gradual and not much of a problem. Would like a quote to fix just the bad one, or both. Would be looking for someone with experience in this job, making sure to have the tiles perfectly level with each other to prevent tripping hazards.

Replace 3 rusted metal railings. Requires welding. Once repaired the iron gate needs to mounted between house and new fence. All tools and materials to be supplied by contractor. Site visit preferred to discuss requirements. Willing to pay extra for additional services.

hi the roof of my driveway requires repairs. Some cracks have appeared and a section fell down recently after the heavy rains.

Colour seal driveway, 50m2 in dark grey

Hi my driveway gate needs to be fixed into the hinges and the bolts need to be screwed back.

Installation and replacement of swing garage door motors and control board. Preferred brand for replacement is Merlin should be rated for 200kg doors.

Concrete driveway 10 metres by 3

Grinding of concrete driveway to remove epoxy surface - about 1-2mm I reckon needs to be removed to then apply anti slip paint. About 25m2

1) Driveway: to replace the existing colored concrete driveway to exposed aggregate; 2) Front Porch & Stepping Stone: currently matching the driveway with colored concrete. Wish to replace to stone textured concrete/ paving stones (eg. crazy paving) Please suggest your quote and ideally come in person to do inspection.

Fixing a Metal gate that dropped about half a cm need to fix the hinge by welding it back on

We require a new Exposed Aggregate concrete Driveway. Area is 25 Sqm

I require an experienced, licensed brickie to build a brick fence with an automatic gate. Looking at 1.5m tall all around. It is a corner block, roughly 25 metres long all around.

To build a concrete driveway for the size of 5mx3m with reinforced mesh. The driveway to connect to existing driveway. Please quote your offer including all the materials.

Garage floor to be done with epoxy. Need the tasker to provide all material.floor area is 8m x 7m

The driveway has 2 gates that are opened by a remote control, but currently are not opening, despite the remote working fine.

Have a brick driveway that needs some attention. Needs a really good pressure wash and new sand. Looking for paving sand or power loc. and to seal the bricks. It’s about 20m x4m

We had 2 crossovers installed for 2 townhouses. The council let us know that minimum 400mm of asphalt needs to be reinstated for both crossovers. I have attached photos of the current crossovers and how the asphalt needs to look (this is a photo from the council and shows the minimum 400mm required).

we pressure washed the driveway and some mortar has come out between the bricks as it was fragile - mortar needs to be replaced in 2 areas (2x3 metre) and (1 x 2 metres) around 5 hours work EXPERIENCE WITH THIS KIND OF JOB PREVIOUSLY IS A MUST

Need to get Four bird of Paradise tree stumps removed from the side of our front driveway