Find an experienced driveway repair contractor in Mornington Peninsula

I have crushed rock to move from the front yard to the backyard. I can spread it out but need to put in place. 1 cm

Driveway drainage grate is stuck and cannot be removed to allow drain to be cleaned. May need to be grinded out. Need grate removed and if damaged to be replaced with same Everhard grate

To replace cracked pavers with thicker pavers to take weight of car. Area is next to bricks driveway. Size is approx. 6m x4 m. Installer to supply thicker pavers. Base is sand on crushed rocks.

We have a U shaped driveway about 40 metres in total. It’s got a bit mossy and dirty and needs a good power wash. A small karcher not powerful enough must have professional pressure washer

Grind a watercourse channel in the concrete driveway 4cm wide and 3.5m long of a graduated depth varying from 1cm to 5cm.

The bottom corner of my driveway has sunk due to the property being on a high sand content dirt, need it to be lifted about 2 inches

Drive way has gone uneven over time and damaged at some places . As it is a trip hazard need to repair .

Needing stumps removed from driveway. These were just plants that have grown enormous and I've been told if left in, they'll destroy my driveway concrete. I can get pictures done later today.

The driveway is made of concrete layed in 5m rectangles The paint has worn off the surface needs waterblasting and repainting Paint will be supplied

Need the side of our drive way patched up. It isn't tiles. It seems to be a mix so not 100% on how to get it done. I'm a single mum absolutely out of my comfort zone with this one and would really love some help!

Existing driveway gate post rotten and fallen on ground. Need it reinstalled and half the gate put on it. Then both realigned Or New driveway gate. Basic design fine.

Install fence toppers to driveway fence approx 20 metres. Also paint with supplied paint

Poor or mix small amount of concrete 1 square meter include reenforcement and stamp pattern

Two driveway swing gates 1.5 m wide each and 1.4 m high. Supply and install front driveway steel/ aluminium/ hardwood framed gates, Merbau slatted to match the front fence, including: two 200mm by 600mm post holes; supply and install two 50x50mm galvanised steel posts/ or hardwood posts set as close to the brick fence post and timber boundary fence as possible; supply and install 50x50mm galvanised steel caps on gate posts if needed; supply and install, two steel gate frames ( or timber frames) fixed in place with galvanised hex head 14G screws; supply and install 90mm by 19mm Merbau lengths to gate frame fixed in place with 35mm 8G countersunk galvanised screws; supply, install, align and test two 300mm galvanised drop bolts for both gate sides.

Need a basic gate at the front of my house in driveway. The width of the driveway is roughly 360cm, the height I'd like it to be is roughly 180cm I have a white timber fence so would need to somewhat match

Concrete ramp as per title and referenced in pics.

Approx 8m3 of crushed limestone will be delivered this week, dropped in driveway. Will need to be moved to paths around the side of the house. Enough room for a dingo/small bobcat (1100 clearance at tightest point) - Due date: Before Sunday, 14 January 2024

We have a short 7m driveway fence we would like painted. Paint supplied. You will need to use your own brushes or spray bottle. 2 coats required - ideally this week or next. - Due date: Needs to be done on Thursday, 9 November 2023

Cut the crack out and concrete the where you cut - Due date: Flexible

You’ll need to spread out the 20mm rock that’s being delivered along the driveway. Driveway approx. 25m long X 4m. At the entrance, the driveway is currently too high for the new gates. You’ll need to dig around 2-4 inches out and smooth the gradient before laying rock at the gates. - Due date: Needs to be done on Wednesday, 20 September 2023