Find an experienced driveway repair contractor in Sydney Eastern Suburbs

About 15m long x 2.2m wide driveway to concrete Remove 11mx1m existing concrete Please send me a quote

We have a timber planked driveway gate fixed on a steel frame, which in turn is fixed by 2 large pin hinges to a steel column. The pin hinges are welded to the steel frame and the steel column. We need to grind off and replace 2 of these old pin hinges, and finish with Col Galv.

Need to patch up some paint around newly installed lights approx 9 in total. Must have professional painting skills

I had a water leak and had to remove 2 tiles from the floor. I have spare tiles that need to be cut and glued back onto concrete floor. The old glue may need to be removed so the tile can sit flush on the floor

Ref: aluminum swing gate door welder or aluminum gate repairer One gate side/door of my driveway swing aluminum gate has been broken from its hinges due to the heavy wind/storm the other day. It needs to be fixed.

Driveway gate has dislodged from it’s fixings during the wind yesterday. Needs to be refixed.

Driveway has cracked Need to fix and lay new cement or concrete

Hi there, Group of 3 townhouses in need of their driveway pressure washed, sealed and painted if that's a thing. Dimensions: about 5m by 20m it is quite big and probably require quote on site visit. Dirveway is dirty and will need some light repairs ( small cracks) to be done too. It was painted beige-ish with green pattern that we would like to keep. Located in 2035 Maroubra, we are looking for quotes to submit to our Strata committee for approval.

I have 4 tiles that have cracked in my driveway. I need someone to cut and replace the tiles. I have the replacement tiles, 3 will need to be cut

Run 240V under 25m long concrete driveway from building to end of driveway. I am told this needs a trench to be dug 30cm minimum under the driveway, lay the cables and reconcrete. Please include the cost of doing this, and acknowledgment on your quote that it includes excavation, laying and terminating cable and re-concreting. When to do it is flexible, but once started, estimate the time it will take to do, please.

I’m looking for someone to remove the existing paint off my driveway, so that it can be prepared, repainted and sealed. I am looking to avoid the paint peeling issue again. For front of house, side and back as shown in photos. Total square metres is approximately 40m2

Clear and remove mud and sand from driveway and clean afterwards.

Need you to remove mud and sand from driveway and clean the driveway once removed.

We need this section of our driveway to be ground back significantly to reduce the slope of it, so that our new car can be parked in the driveway. It is currently scraping the bottom at the hight point of the driveway. The marked up driveway section is 3.7m wide and 2m deep.

I am looking for some professional to help me build/put in place a custom driveway curb ramp please. This is to prevent my car from scraping coming in and out of the garage. Could be made from rubber ideally. I am just listing the cost for the design, construction and install. I will of course pay for the materials etc as well on top. Thank you

Hand Wash two gates using soft cloth and detergent only. These gate are wooden and need to be carefully washed. No high pressure at all. I can supply all materials. The task should be take about 1.5 hours. Photos show both sides of the two gates - Due date: Needs to be done on Wednesday, 20 December 2023

We have had our driveway honed but there are some small patches remaining. This needs to be finished and then coated in clear matte finish EXTREMELY NON SLIP epoxy and the faux turf put back down into the tracks. Very early start please. - Due date: Needs to be done on Thursday, 30 November 2023

Gerni inside the garage and driveway. - Due date: Needs to be done on Friday, 3 November 2023

Replace terracotta tiles in part of driveway to match existng - Due date: Flexible

Need an automatic gate for my driveway. Need to have aluminium vertical pickets look. Size is 3.0m wide x 1.2 high Power point is there. Its in between two walls so a singlw swing gate is best - Due date: Needs to be done on Thursday, 5 October 2023