Find trusted local electricians in Elwood

Intercom front gate not working and the locking mechanism is not aligned so it can't be closed.

Looking for a qualified electrician to install 4 point points in various rooms throughout my apartment. 1970’s ground floor apartment double brick.

Need an electrician to solder the black wire back onto the electric gate lock mechanism.

Spa is empty and new light ordered, should be a simple fit. Its a spa electrics retrofit.

One of the The connector pins is broken and just pushes in when connecting the parts together

Hi All, I need a handyman to complete the following tasks: - Remove black mould and treat so that it doesn't come back (minor black mould, not severe) - Install a new tap line - Repair/replace an electrical switch - Repair hole in stormwater pipe - Install 2 new fans in bathrooms If you cannot complete all these tasks just quote it accordingly.

Electric bike speed working, battery light and indicator lights working, could be the motor

Any local electricians available to swing past my place today? I need to replace 2x hard wired down lights. I have the lights, just need someone qualified to install them.

Hi there, I need an electrician to fix my living room ceiling light. It flickers occasionally, though it works fine most of the time. The flickering usually lasts only a few seconds and happens once every few nights. I believe the issue is with the electrical wiring rather than the LED strips themselves.

The outlet for the dishwasher short circuits the home. The outlet is under the sink. When I plug the dishwasher into another outlet, it works properly. I need the circuit checked/replaced please. I have tried the toaster (another 3 pin appliance) and it did not short circuit the house. I’m also hoping to replace the 2 globes in my range hood.

Chillmax bar fridge bought 2nd hand - turns on, light works etc but doesn’t cool. Compressor is working (vibrates and is warm when running). Fan works also Pics below attached

I need assistance with the following: Installation of Hard-Wired Smoke Alarms: Interconnected smoke alarms in accordance with AS 3786 in the following locations: In every bedroom In every corridor or hallway associated with a bedroom, or in an area between bedrooms and the remainder of the building if no corridor or hallway exists On each storey of the dwelling Emergency Lighting System: A lighting system to assist in the evacuation of occupants during a fire, activated by the smoke alarms. This can include: Lights incorporated within the smoke alarms Lighting located in the corridor, hallway, or area served by the smoke alarms Based on my simple plan, it appears that we will need 4 smoke alarms and 4 emergency lights.

I need some LED lighting to be put around an exterior garage of 9 metres. On a laneway , it is too dark at night. Can provide the material if you like.

Run new cable for induction unit in new kitchen. Pretty easy access in wall and roof to main swtich. Must be qualified electrician

Some of the LED's on my car brake lights arent working, ive attached photos of the lights on pcbs boards, and they can be taken out of the car so would need some of the led's fixed, looks like about 16 of the little leds arent working, im in elwood area and can drop the lights off or can be picked up or worked on here, which ever suits

Transformers replaced for 3 downlights and flickering lights settings

3 transformers to be replaced on my down lights and flickering lights when light brightness is adjusted

We’d like to remove an old gas heater that’s connected to the gas. Job specifics: - ensure gas is disconnected/sealed (in other words: no leaks) - disconnect electric heater, copper pipe and exhaust (in other words: appliance is no longer on the wall) Please note: Removal of trash from site is not required.

We’re looking for a second opinion on a continuity test performed by our landlords electrician. We don’t need a full fault find or investigation we just want to get a report to verify that there is or isn’t continuity between a screw in the wall and particular socket. Should only take a few minutes to perform test and confirm.

Downlights keep flicking off, need an electrician to check and remedy/replace if faulty. Light switches also need to be checked and potentially replaced. Further works potentially available after these initial works.