Find trusted local electricians in Prahran

Hi there, I need 15 of these metal downlights replaced with a more modern downlight. . I will purchase the downlights, thank you

Got a quote for $2,035.00 to repair intercom. The job is to rewire cabling from a power supply at the front electrical cupboard to the unit 4 BTICINO internal monitor. I think we can just tie a new power cable to the existing faulty cable and feed it through.

Installing some power points, and installing a ceiling fan (already have) in the bathroom.

Needing a qualified data technician to relocate my NBN box to a new location. Location is on the same wall just 2.5m away due to renovating the space.

Fuse blown in car. Needs to be fixed or replaced

Replace 5 x down light transformers, 2 of 5 not working, 3 of 5 to support new smart LED, bulb spec pics added

I need the electrical lead replaced on a table lamp. It had a lead from Morocco which exploded. The new lead also requires to have a cord switch. I am happy to travel to you (within 5km of Prahran VIC)

I'm the proud owner of a vintage Rickenbacker 4001. I recently bought some new pickups for it, and tried to solder them in myself. Unfortunately, I'm an absolute amateur and have stuffed it up - despite my best efforts to follow the schematic, the bass doesn't produce sound. My band has a show this Friday and I'd really love to have this bass available for it. Would be very grateful if someone handy with a soldering iron could save my dumb ass :)

I have a light fixture that has broken. I've purchased a new fixture but it requires an electrician to install it to the roof of the bathroom.

Supply and replacement of 2 clipsal hard wired smoke alarms

Install plug under bench using power from existing power point. Note that walls are double brick. Cabinetry work has started to make space for the dishwasher where pictured. The door cover just needs to be unscrewed to access the wall.

I need a handyman that can fix electronics to obtain and solder a $6 Jaycar switch into my recliner sofa. https://www.jaycar.com.au/spdt-250v-3a-miniature-micro-switch-with-lever/p/SM1038 I have the part number and photos of how to fix but I'm not physically present at the moment so can't fit myself. The sofa is currently intact but stuck in an open position. It has two switches at each end (4x in total). One to open, one to close. Only one of these on one side has broken and this will need to be de-soldered and replaced with a new one. It took me around 1 hour when I did it previously. The fix can be crude as long as it works. It's not a precision soldering affair. Process: - Disconnect power pack - Flip sofa onto it's back by tilting it - pull back fabric on the broken side - use a stubby (or short) phillips screwdriver to undo the switch circuitboard - Desolder/cut off the broken switch - Remove the steel actuator lever off the new one (not needed) - Use pliers to trim tabs of the new one a little so it physically slots into the circuitboard holes - Resolder the new one in it's place - Refit is the reverse of removal, refit battery pack and test sofa (should work fine) Please refer previous work that you've completed in the response to the task. I'm looking for someone comfortable with soldering a simple circuit board (refer my pics). Apartment is located in Prahran, Melbourne, 3181.

Install only. No removal.

- Miele induction stove not working - Electrics need to be reset - Fuse required to be check for replacement

Air conditioning installation

As the title says - government mandated electrical checks for tenancy

Need 7 PowerPoints changed over and 1 switch. I have already purchased the PowerPoints and switches.

2 LED downlights go on and off intermittently a couple need changing

Need 2-3 new power lines to my back room which already has the cables under the floor A couple of main switches will be supplied

Install plug under bench using power from existing power point. Note that walls are double brick. Cabinetry work will be done to make space for the dishwasher where pictured