Find trusted local electricians in St Kilda East

Electrical wall heater disconnected, smoke alarm hard wired installed and a quote for install of split aircon

Smoke alarm hardwired install and an electric wall heater to be disconnected and removed off wall. Also quote for split system aircon install

Need the following works executed: 2 light switches replaced (I already have the replacement switches) 1 plug installed for LED strip lighting (easy installation as exposed studs Cap 2 lose wires

I need a qualified Electrician to install a split system air conditioning system onto the roof of an apartment complex (accessible by man hole) and unit place on internal wall

Looking for Call-out fee for AC technician & electrician that can do a diagnose and repair for a 3 split unit - main unit located in rooftop of unit. The unit electrical board was replaced recently (November 2024) and now the power circuit breaker is tripping, unable to power the unit. AC technician revisit work by pulling out the isolator and testing for water present, etc (nothing was found) Electrician was sent to site to replace breaker from power unit and after doing so the power is still tripping the circuit. We believe either the board in the AC unit may be blown again cause by some intermittent issue or the wire going from the power board to the unit is burnt/shorten somewhere. Please provide price for initial diagnose.

Call-out fee to send electrician to unit to replace most likely what is a power breaker on the switch board of unit that has blown/burnt recently The breaker is for an Air Conditioning unit which has been serviced recently (2 months ago) and the AC technician had been on site to check again and confirmed there is no power going through the circuit breaker while there is power in one side (other breakers) there is none on the one for the AC unit, probably randomly tripping assuming when the board blew prior getting the AC serviced last month or so. Require to replace breaker and test for electricity going through the line to the AC unit.

Remove current door lock and install electronic lock Eufy brand.

I need the old heater taken out and a new heater purchased and installed.

oven disconnection. its dual fuel so both electricity and gas need to be disconnected. must be licensed.

Hi, I am Looking for a qualified electrician on hourly rates for a series of small /medium jobs preferable on Friday 20th or Monday 23rd December.   * Fix kitchen track light, or replace existing fitting, current light only has 2 lights that work, and light keeps dipping in and out. * Replace and install a new bedroom ceiling fan (I will supply parts) * 2 x bedroom lights to be fitted, 1 with a new light fitting. * 2 x bathroom outdated lights to be replaced with a new light fitting/light. * Front of house recessed light needs to be repaired current light not working. * Need exhaust fan to be replaced in toilet area .   We will supply parts.

Need to connect three power points. May need to extend wiring on one. Also put in light switch (earth wire will need to be extended on this.

2 jobs. 1 move wired in smoke detector in ceiling. 2. Check issues with down lights under kitchen cupboards. Quick job! Can anyone squeeze me in today?

Hot water is running brown and cold is normal. Hot water heater either needs flushing or replacing. Can someone please diagnose.

Hi, I need a qualified professional to conduct a smoke alarm test and provide written report for owners corp. I have one alarm in my apartment. Thanks

Putting a new floor board on my house. Took out the subfloor and need electrical checked

Install dimmer switch on switch plate. Current switch plate only has light switch, have purchased new switch plate and dimmer. Two light switches to do.

I'd be looking at getting the following 4 x electrical tasks done. Important: Due to a new property settlement time on Mon 21st Oct, and other trades which are already scheduled in to start works on Tues 22nd Oct, I'd would need these items below completed late afternoon (4pm onwards) on Mon 21st Oct / before Tues 22nd Oct. 1. Run / set up power for when waterfall peninsular bench will be installed in approximately 1 months time. The bench will include 2 x GPO sockets at either end, and a LED strip light. These items will all be placed underneath the stone top, and located at the top corners, behind the cabinetry (in knee recess). 2. Hang a pendant light above where the peninsular bench will be installed. Including installing a double dimmer switch on a wall near to the where the bench position will be, used to control both the LED under bench light, and also the dimmable hanging pendant light. 3. Run power (install GPO) on bottom of wall to a where the standalone cabinet will be installed. 4. Set up TV Unit GPO (and HDMI / cabelling channel outlet) half way up a wall, ready for a wall mounted TV install.

Have recently tiled small kitchen. Now needs 8 tiles to be cut with an angle grinder (?) to fit final tiles around electric sockets.

Looking for electrician or handyman to fix up a couple of things. I already have the new parts.