Find a local electronics repairer in Sydney City CBD

Left trigger has stopped working

I have two bathrooms and I would like to replace taps in both of them. I am going to supply my own taps.

I need someone to repair my WH-1000XM3 Wireless Noise Cancelling Headphones as they have stopped charging and turning on.

I need help assembling a basketball game. You will need basic tools such as a screw driver and a hammer. It is a two hoop Arcade style game. Should not take more than 45mins to assemble According to instructions.

I need Audi electrician who check my meter sign and fix it it usually come when I turn on the right indicator

Shower dripping Basin tap dripping

my straightener is flashing red and beeping

Audio Outboard Unit - PSU Repair (Aphex Channel + PSU Circuit Diagram) I need an electrical engineer to diagnose and fix my Aphex Channel. This is outboard gear from an audio studio. The unit decided to stop turning on one day, despite being plugged into a high-end power conditioner. The unit's circuitry should be mostly intact, but I believe there is an issue with the power supply circuitry. These units were notorious for PSU issues, and this is the 2nd unit I've had where the PSU died. Upon internal inspection, there was no visible damage - unlike the 1st unit that broke, which had clearly burnt components. Note that the unit would sometimes take 20 seconds to turn on after powering it up, but this was supposedly normal behavior. I was technically covered by warranty when the unit broke, but the manufacturer had recently stopped producing them, which they claim allowed them to reject my warranty. Happy to ship the unit, ideally within Australia. Flexible on budget & time. Cheers.

external piece of plastic has broke off from hinge so the earpiece no longer sits snug on my ear

We require assistance to assemble 5 laptop stands and 5 docking stations in our CBD office opposite Town hall station. Estimate 2.5 hours.

I haven’t dropped my straighteners they just started beeping and not warming up.

I need a certified electrician to install six new ceiling lamps. The installation will require new wiring connected to the existing wiring shown in the picture. The address is Oxford Street, Woollahra. Parking is available. I only have the lamps shown in the picture, no wires and globes.

Circuit board needs convection soldered on

I have 7-8 table tops that need to be replaced. The current tops are glued to the stands with super glue, so you will need to remove the existing super glue and attach the new tops.

my sony wm1000x4 is not charging, no red light when it is being charged and it doesn't turn on

We do Outdoor blinds We need x2 Zipscreens installation By tomorrow or Monday Ongoing work

There is a glass piece of furniture, in which the top piece has become unsealed from the side pieces. The top must be sealed to the two sides, involving about 0.5m of silicone seal on both sides.

Need to build a gypsum plywood partition divider to split office space, need a door attached aswell. The setup can’t spoil the floor as it’s a rental space.It has to be divided right in the centre and not touch the ceiling. The total space is 37 square metres. The partition should be approximately 6 metres wide and 3.5 metres high

Repair concrete steps. Slight damage on 8 steps. Worker to provide all tools and materials. - Due date: Needs to be done on Saturday, 10 February 2024

Need to lay data cables from server to 5 different rooms for WAPS. The data cables should be run through the ceiling and also installations of 5 WAPS on the wall. - Due date: Needs to be done on Tuesday, 30 January 2024