Find a professional gate installation in Epping VIC

Looking for someone to remove and replace the sinking concrete slab under my gate motor, and also install new gate rails. The current slab has dropped about 5–8 cm and needs to be properly excavated, the base compacted, and a new slab poured. Scope of work: Break and remove old concrete slab Excavate and compact the base properly Supply and pour new concrete slab (level, suitable for gate motor) Install new gate rails (I’ll supply the rails, or let me know if you can supply too) Optional: Install anti-vibration pads and help re-mount the gate motor Clean up and remove waste Prefer someone with concreting and gate installation experience. Flexible with timing but would like it done this week.

Would like to to install a colourbond gate. The width of the space I have wall to wall is 1400mm wide. I would also like it to stand 2000mm tall preferably but am flexible depending on availability of sheeting. There is currently a temporary gate which will need to be removed to complete the job.

Looking for someone to properly adjust the rail on my front gate in Epping. The motor works perfectly, but the rail sits slightly above the spinning wheel, causing movement issues. This was repaired once before, but the problem came back after a few months. I’m after a professional, long-lasting fix – not a temporary solution. The rail needs to be aligned properly so the gate runs smoothly and doesn’t break again soon after. Should be a straightforward job for someone experienced with sliding gates, motors, or metalwork.

Timber fence and double gates replacement 5 metres of fencing 1.8 metres high Double gates aprox total 2.6 metres wide

Gate repair needing to open.

Gate needs to be moved from current location to end of driveway. The width of new location is maybe 12 cm shorter than current location. I’m thinking the whole thing could just be moved as is and would close a bit wonky, but might need smaller posts to fit. Or gate could be cut smaller. It’s a simple metal frame, welded.

Front gates drag along the ground. Gates will need gate wheels and to be realigned so that the gates close properly.

Approx 80sqm of exposed aggregate i want to cover or sand down. My kids getting hurt and looking for the most affordable/ practical solution please! - Due date: Flexible

Hi, IT guy for installing turnstile doors with paxton system to clubfit software for a gym. - Due date: Flexible

Front fence and a remote control gate - Due date: Flexible

Hi I need someone handy to help fix the hinges on my side gate. Please have a look at images provided, advise on the best way to go about fixing and quote for both hinges to be replaced. Thanks! - Due date: Flexible

Put up corrugated clear Perspex onto a pergola. Require own materials. 5.7m by 1.7m. Also please remove the old clear Perspex which is only covering a small area of the pergola. Will pay for the materials used. - Due date: Flexible

Need a 1.8mtr high colorbond gate for approx 1.2mtr opening. Will need to remove existing small wooden gate (in photos). - Due date: Flexible

Gate needs to be fixed on wall side . Hinges gotten off the wall because of wind or something. Only one side of double drive way gate. - Due date: Needs to be done on Tuesday, 6 June 2023

Need a new colourbond side gate installed - Due date: Flexible

Need a sliding gate, designed to match existing fence, needs concrete foundation, centsys d5 eco motor, Merlin receiver, and power ran to system (4 meters to corner of house) - Due date: Flexible

Gate needs to be put back hinge , fix the latch , screw back the Plinth - Due date: Flexible

Need to install my sliding gate. Everything is ready and just need to instal vevor sliding gate opener to the gate which is already there - Due date: Flexible

Need to fix the lock for outdoor gate - Due date: Flexible

Need a Qoute for sliding gate - Due date: Flexible