Find a professional gate installation in Inner South West Sydney

Fix gate as it’s come off its hinges and old screws are still attached to gate

Supply and install 3.4m color bond gate (Surf-mist ) at backyard between 2 duplexes, the posts will be bolted to the brick building wall and to the concrete wall in addition to the core hole in ground, the ground surface will be artificial grass within 2 weeks , the gate hinges will be on the retaining wall side

Screw holes are too big. Tried using larger screws but did not take.

Electronic gate FAAC motor not working. Manual mode not working.

Fix the broken Gate. See the pictures. You have to get all the required hinges or screws or anything else.

I opened the gate with remote and then I tried to close it back using both remotes and it won’t close again

Baby gates have been screwed into the wall. We need them removed and the concrete wall patched up

-Installation only of sliding gate/fence -I have already purchased the gate etc. with all components -See attached image for plan -Dig holes for the 5 posts (approx. 600mm deep) -Supply concrete bags for posts/gravel -Include removal/disposal of hedges and stone columns (see attached) -Include installation of concrete slab for gate to slide on over mulch (see attached) -Install gate motor with remotes working Looking for a complete installation from start to finish with nothing left to do. Looking for a good job by someone who has experience

Its driveway side door thats made in wood. But the wood is rotting. If someone can weld me something that can lock to fill the gap of the door is sufficient

I need new keys/remote for the shutter gate, not a replacement but new remotes that only I have access to

Need a 3 section colourbond fence installed and gate. Have the fence already. Gate will need to be built from the extra parts that I have.

Install a gate Second hand or new Measurements 12ft

Replace a new latch on common area gate

2 gates I want to automate . Put a motor so they open and close by remote or wifi.

I need to install (from scratch) a small backyard gate between the house wall and the timber fence. The gap is about 125 cm. Probably the installation of some sort of pillars will be needed. I would prefer the gate's design shown in the photo

x2 gates to have springs installed so they close if left open. Springs will be supplied

Either fix or source replacement for pool fence gate and lock, and install. (We will pay for products separate to the labour on proof of receipt )

We have two outdoor gates that need replacing. I would like them to be treated timber in a simple picket arch with a Z frame reinforcing the back. They will also need to be attached to the wall with hinges and latches. Gate sizes: Side garden gate 97 width // height approx 157cm https://www.bunnings.com.au/900-x-1800mm-gate-cypress-arch_p0124921 Pool gate Width 83cm // height approx 140cm There are prefab ones at Bunnings for $148 that will suit the larger size, but not the smaller. The smaller will have to be built or perhaps we can cut another Bunnings one to size. Will need you to purchase materials after we discuss design, build gates and install.

About 2.4m between house and existing fence. Need a fixed piece about 800mm-1m at the house and the rest gate plus a two way lock… also need a two way lock on an existing gate… I am located in Padstow 😀

The gate in my driveway has fallen off at the hinges on one side. I need a new set of hinges on that side and then to have then reattached.