Find an experienced handyman in Arundel

Garage door fix Not closing evenly a couple of wheels are off the rail also one side wire is off as well.

I would like a ceiling fan installed into my lounge room I have bought the fan just need it installed and wired up

Need help to fix bedroom blinds. It cannot be pulled up

Instal 2 internal doors - one slider one normal door. Require framework and gyprock

Good morning Last weekend, during the hot weather, I attempted to close the sunroof, but a section of the fabric remained stuck inside. I have attached a photo for your reference. My car is a Nissan dualis. Could you please provide me with a quote.

1x door fly screen 1 x slide window fly screen Need to replace a new one

Remove 4x old remote ceiling fans and replace with new remote ceiling fans.

I need to install 2 wall fans on a Concrete walls. All I need is to hang it safely. Drill and screw. (No need for any electrical or power points. ) I’ve talked to someone before (Tim). But I lost him.

Medium size hole to patch and paint and frame of door to be replaced and painted

Window Venetian blinds arent sliding along the tracks, somethings broken. Please fix.

Move a big chandelier from a high ceiling

I need assistance with remodelling my kitchen.

Paint/primer supplied. 12 doors/frames, 5 window frames, 1 ceiling (roughly 40 square meters) Skirting board in bedroom

High mounted, teardrop chandelier. On switching on the lights are steady for few seconds then move on to a rotating routine with different groups of lights, mounted it the base plate, coming on and off in sequence.

Screen has a dark line at the top, backlight issue. Needs repair

put a door handle on a door - I will supply the door handle; and put up two curtain rods that arent straight.

Need someone to supply and install edge tape into two kitchen cupboards as shown in picture. One is a corner cupboard.

About 8 flyscreens on windows and one sliding door screen. One window the security screen needs to be taken out and refitted, but this one can be done separately if not able to take out and put in pot rivets.

We need 7 internal doors replaced, handles need replacing and holes drilled to put into the doors. We have the new doors ready to go.

The screen door is difficult to lock. You have to wobble it around a bit for the lock to latch properly. Looks to me like the holes that were cut for the lock to match into, are not totally lined up? Or maybe the hinges are just uneven. I’m sure it’s a 5 minute job for someone handy.