Find an experienced handyman in Pacific Pines

Garage door wont go up. Large spring on the top on the right snapped last night. Need to replace both and make sure door operates properly after this.

Repair hole in plasterboard wall

Render/outside of house crack and chip repairs

I have a couple of loose or broken tiles on the top of a retaining wall that needs fixed. I also have a stepping stone that is no longer fixed i. place that i’d like secured

Auger has stopped initiating on a green mountain grill. Looks like a wore has come loose. Will need someone who can find out where the wolire has come from and reattach it.

Handyman required install the bedroom door

Fly screen on bedroom balcony sliding doors x 2 have holes due to pets. Have purchased some stronger mesh, need installed

The bottom part of the plastic shower screen frame broke, and I need someone to fix it.

need my cloths dryer cabinet hung on laundry wall

see attached Assembly Guide

Toyota hiace side mirror needs replacement

Need car roof lining repaired for 2015 VW polo 5 door hatch. NO sunroof fitted. Also need drivers door armrest material glued as it’s coming off the armrest. Please quote. Area pacific pines

Replace one side of existing hardwood garden retaining wall approximately 4m long by 500mm high.

The cable at the side of the garage door came off the roller so my husband has loosened the rollers on either side and the pretension spring has unwound so the cables are now free though the spring needs to be retentioned and the two rollers tightened back in place.

entrance door 2040 x 1100mm garage door (painting only) 2100 x 5000mm door, lock & pull handles are provided door frame to be done - 2080 x 1140mm opening

4 pet screens (140 x 80) to be installed. Super quick and easy job for someone with the right tools and know how. It's just 4 screws per screen :-)

Need the torsion put back into the spring, the cables on both sides replaced and spooled back onto the spindles. The central bolt from the arm and chain drive put back in, then just a calibration. Everything has been well used and operational, is wired up and good to go. Photos supplied.

Less than halfway through DIY project and realised I was not doing a tidy job . Need someone to Install a 184 x 19mm x 1.8m panel onto our wall. I’ve already drilled holes from a previous job and now I’ve stopped myself from ruining the wall further. Thankfully the panels should cover the drilled holes. Images attached.

Need electric drill simple set up 1.5 hours aprox

Fit/replace an existing gate lock and intercom system. The new system is an eyevision two wire touchscreen and video door station. The elec latch is fitted and wires may need to be replaced (have the parts and a cable just not sure if it needs replacing)