Find an experienced handyman in Seaforth NSW

I have a Yamaha ef2000is inverter generator which works but runs rough..not starting. About 1 year ago it was starting but running rough and only on choke. Has had stale fuel for long time. I suspect carb needs cleaning. Has new sparks and oil filter. Also have a 7hp pressure washer per pics. After long time no use started it up, worked for few minutes then stopped. Have replaced spark and fuel but still does not start unless I spray and engine starter into the air filter than it starts for 2 seconds and stops. I suspect carbs need cleaning as well.

Install pull-up bar into rendered brick wall

Install a door for a bedroom, need someone to go buy the door from bunnings etc

Need to repair various issues. Some materials provided but not all (need to get from bunnings). Includes: - Painting (patches) - Rust repair + prevention

Need a dog door installed

I need a dent on the we to be fixed and painted

1. Toliet light and fax replacement 2. Shower knob fix 3. Maybe a few other small tasks

2 beds moved between rooms internally same level. Sliding cupboard doors fixed. Sliding external doors fixed

Fix chipped render 3 spots

Handyman to repair missing / broken section to door jamb and trim, refer photos.

Install a new Door Jam into a new stud wall. The old jam is gone as is the old wall. The new wall has the last stud loosely fitted (not nailed) to allow for perfect fitting of the new door frame. All timber is on site. The new door jam will need hinge fittings chiselled out to fit the old door. The old door - in near new condition needs to be rehung int the new door jam.

After an electrician has installed fans and new power points, I need the cuts and holes in the gyprock plastered and prepared for painting (no painting required for this job). Work required: - 3 coats for 5 x circular cuts - 3 coats for 2 x square cuts on roof for fans - 2 coats for 7 x circular cuts(they already have had first coast & sand done, see photos) - 2 x coats for 2 x square cuts on roof for fans (they already have had first coast & sand done, see photos) - Sand and finish in preparation for painting I expect this will require 2-3 visits. I'm flexible on timing. Bring your own tools (must include plasterboard sander with vacuum). Multi-purpose joint compound and plasterboard joint tape provided. If you need more details or photos, please let me know.

Remove mat from large oval springfree trampoline and replace with a new mat.

Bathroom door handle turns but door won’t open

I need a tiler to cut an existing pool tile and install new flush skimmer box tile insert. Labour only material is on site

Need an old blind taken carefully down and blackout blind installed. I already have new blind purchased

The build is due to be complete around March. Check measure needs to happen very soon so the cabinetry can be produced. The cabinetry will be made in China by a reputable factory. Installation will be around March.

High quality ceiling repair required. Image attached. Repair and repaint.

As can be seen on the photos I need to cut back the pipes inside the wall to be able to put tiles on them. 2 cutting back and 1 uninstalling the tab. Thanks

Please fix 7 items to gyprock walls around our house. Items: * 1 ironing board hanger/stand in laundry. * 1 small handmade bookshelf (4 screws) in kids bedroom. See photo. * 5x slimline art hanging system rails in various rooms. Likely into stud since against ceiling. See link: https://www.thegallerysystem.com.au/product-category/slimline-art-hanging-system/#