Find an experienced handyman in Shailer Park

Outdoor decking roof and glass fence

Hang 24 frames in stairwell

I need a broken derailleur replaced on my Stealth commuter e-bike. I already have the spare part - I just don’t know how to do the exchange.

replacing thebold toilet seats toilet seat provided also the outside clothes liner has some of the wires broken need to replace

Pavers to be installed on a flat ground

Looking for someone to supply and fit security screen windows and doors. I already have all the measurements

Install new ceiling fan in patio area.

Someone lost their temper and put her hand through the wall. In need of someone to fix hole and repaint

3 x Base cupboards with drawers for kitchen with counter top. Storage cupboards x 3 under stairs

Reinstall our stratco gate (hinge attached) + pop 4x fan blades back onto installed fan base (will need to supply screws for both) thanks

7 Doors to be installed. 6 internal and 1 external for kitchen to back yard. Low set. no stairs, easy access. Only door fitting and drilling holes for handle installation after paint.

The curtain was pre-installed It came off from the center point of attachment to the wall The middle bracket came off from the wall The wall need to be repaired first in order to install the middle bracket For reference I have attached pictures and this is not a big job

Three small sections of plaster cut out and replaced in kitchen

Fence door hinge falls off.

Odd Jobs (chain wire fence removed, downpipe collectors fixed, gutters cleaned out & a dryer to be hung)

In need someone to Install a pool gate latch . The latch is already purchased with parts available and is to replace an older one that got damaged so for handyman who knows what they are doing or installation instructions should be a 10 minute job if you have a drill and screw driver

Kitchen splash back gyprock patching. Larger square is roughly 600hx800w, with a further 400x200. Second wall is 200h X 2700 w. Hopping to get done asap.

Need someone to re-silicone the edges of the shower base. I’ve removed all the old silicone - and attempted but I’m not very good at it! Can supply the silicone.

Need to remove old mount that’s busted and replace with a new one - supplied.

Amendment to the beneath initial request.... How about we just go with 1 fixed glass panel 900mm long? Would still need to be some form of packing as the tiled surround area sites about 26mm lower then the bath lip but would only need to be 900mm long (it will all need to be sealed tight of course around it's perimeter and ends) and I will still need the old shower screen removed and the holes etc patched up. ****************************************************************** I need to replace the shower screen (I will need the old one removed and the holes etc patched up). I need to make it wider & longer so as to sit on top of the tiles on the outside edge but there would need to be some form of packing as the tiled surround area sites about 26mm lower then the bath lip (it will all need to be sealed tight of course). The outside measurements of the tiled surround measure 1575mm long x 770mm wide. Ta