Find an experienced handyman in Upwey

I need a flyscreen made up 83 by 130 that has a hole cut out so window handle lever can operate through it

I am a Roof Plumber and require someone to hold the other end of a metal flashing for me. Completely safe work and I will only need you for about 45 minutes.

Please help re attach flashing to veranda. The flashing is in good condition and pop rivets have been used previously. Please bring own equipment and pop rivets. Thanks!

Install a curtain rod and tighten another curtain rod that has come off the wall.

The pull chords which are attached by wire cable have broken and double leather modular couch can’t recline. Reattatchment required. The left hand side of couch has pull lever (black) on side of couch, the cord/spring has become loose or disconnected from silver lever under couch, needs reconnecting/hooking on to lever to pop out footrest. On the right hand side of same couch, the handle has broken from cable which pops out footrest on the right, needs reconnection. Top left and bottom right pictures go together.

There was foam glued to the brick, I have removed bulk of it but there is some still left. I have used acetone , putty knife to scrape it. Just want to get the remaining one off. You could try a fine sander. I have acetone and the putty knife and fee hand sanding blocks. Or anything else that won’t damage the bricks.

I need a plasterer to fix 3 holes in my ceiling and 6 holes (only 5 pictured) in my wall

Remove sliding door, replace flashings, level the door frame, reinstall door and completely water proof with corking

Clothes line pulley system not working so can’t bring down rotary clothesline. Hoping someone can help with repair. Thanks

Embarrassing but we just have not had time to take down our Christmas light display. Need a ladder, some roof climbing and patience.

Hi all, metal plate has broken on the top of my log burner. Could some quote a repair Thanks, Edwin

I need a clothes dryer hung up on a tiled wall

I want to remove cracked mirror glued on wall behind electric stove W 450mm x H 600mm

Wooden barn door & rail requires installation to plaster board, being careful of wiring in the wall. Approx size 2120mm X 920mm X 40mm & 38kgs.

Hi, we need some rotting decking boards replaced, area measures 3.45m x 1.80m, it does not have to be new boards, second hand leftovers will do. It’s the area up to the left corner where the down pipe is. We are getting the property ready to sell, so the job can be done any time from today, Thanks :) - Due date: Before Tuesday, 9 January 2024

See also pic's attached. 1. Backdoor: needs a small handle to be able to open + flyscreen needs replacing 2. Inside door to have a floor bolt sourced (ie purchased) + installed .. or potentially a door hook (for discussion on what;'s posible) 3. Need Keylock installed (wall mounted, outside) 4. Deck needs repairing 5. Door handle-sized hole in wall + door stop (so it doesn't happen again) - Due date: Flexible - Due date: Before Sunday, 10 December 2023

Water leak has caused cornice damage. Approx 8m needs to be replaced and repaired. - Due date: Flexible

Hi all, We have a 11 month old who is zooming around the place and I am worried the large mirror we have isnt secured well enough to the wall. Could someone help Thanks Edwin - Due date: Flexible

Carport roof that has been sitting there for a while and we haven’t had the time to install it Make me an offer! - Due date: Flexible

We have an old metal (steel) greenhouse, which is in four sections. We need it cut down into managable smaller sections so that can it can be put to one side and taken to the tip a later date. Someone with a larger angle grinder and metal cutting experience will be able to handle this job. Metal doesn't need to be taken away, but tasker can offer a price to take it away as well. Block is flat, and power can be run to the cutting area easily. Note the glass has been removed from the glasshouse windows. - Due date: Before Wednesday, 30 August 2023