Find a professional pergola installation expert in East Melbourne

Need a certified and licensed (must have) roof plumber to lay sarking under a pergola roof. You'll have to take the roof off, put sarking and put the roof back on. The roof is pitched at somewhere around 20-30 degrees. One side colorbond sheets measure about 1.7m and other side about 1.4m.

Repair damaged facia, redo the pergola

Remove the current pergola and part of facia as needed. Construct a new pergola.

Assemble a pergolux S2 3 x3 m aluminium pergola

Open pergola needs a roof out of color bond steel roofing sheets in black. ( night sky). The pergola is around 4 m long and 3 m wide. The roof is flat; no grade The sheets will be 3.1 m long and will have their end folded down to discharge the water out onto the garden bed below. You will need supply and install all material including top hats and screws and flashing.

I need rotten pergola posts replaced

Pergola timber 3 beams and 1 post replacement: rotted due to weather and age

I need a pergola and cover the flooring outside our house. It needs to be non slip as it does get wet when it rains

3.5 x4m slatted pergola needs to be cleaned. I’ve started doing it but run out of time with other jobs I need to get done. It’s not difficult- just a bucket of warm water with some Handy Andy and some microfiber cloths (which I can provide) and wipe off all the built up grime green moss/algae. Water needs to be changed a few times over the course of cleaning. I can provide a step ladder but you can also use the outdoor bench to stand on if you prefer. Top face not part of the job, just the sides and bottom of each slat and the rafters holding them up.

Replace pergola roofing sheets to flat clear plastic (as imaged)

- Replace 5.2m x 2.7m laser light on rear pergola - Add extra aluminium rafter to carry new sheets

Cantilever pergola Timber Length 4m

Need a pergola re roofed in laser lite 3000 the detentions are 6mt x3.3 mt

I have an existing pergola and l require it to be re covered with thick laserlite 3000. The demantions are 6mt x 3.3mt

Remove the current roofing sheet Paint the Pogola and lay the clear polycarbonate roofing sheet ( same line of the house is enough )

Disassemble a Mimosa Pergola from backyard and reassemble Pergola on back deck. Have the instruction manual for assembly and the Allen keys used for assembly

I want to build a pergola over my deck with UV polycarbonate sheets roofing. The deck area is 4.3x5m. See photos for the area. I didn't prefer connecting to the eave as the height will be low. It would ned to be 300-400 above the eave at one side. Please list in your offer the below items: - construction materials (timber, steel, aluminum) - Size of rafters, main beams, post and footing if required

Palm leaf palapa top installers needed to replace four thatched pergola panels onto the existing 3.5x3.5-meter bamboo frame. Estimated time for task: 4-6 hours maximum. Thank you.

We have a pergola area that requires new laser lite roofing installed

Paint pergola in picture Some areas will require sanding Ladder and drop clothes will be required (to avoid getting paint on table and decking). Paint will be supplied.