Find professional window and door services in Mitcham VIC

I have a built in wardrobe - approximately 3.2*2.3, would like to put up a sliding door- photo attached. Just simple sliding door with no mirror Can you please quote me a price with material and installation. Thank you

Sliding door stuck and needs repairing

Hanging an internal hollow door (replacing an existing) - size 2040 x 820mm. Door and hardware already purchased.

Our house has a large shed with doors that slide side to side like a factory rather than roller doors. Over the years the shed doors have sagged a few mm in the middle and now catch on the guide below making them difficult to open and close. I've spent significant time attempting to adjust the bolts at the top but the problem is whilst you can tighten the bolts to raise the doors, this causes the bolts to grip on the runner at the top (now blocking the doors moving entirely). I want instead to lower the guide that sits under the doors in the centre of the shed. I can see a couple of ways to fix this. My preferred method would be to cut the door guide off the picket stake it sits on, trim the picket stake down 20mm and then weld the door guide back onto the same stake. This will be visually the best option. A second approach would be to cut the door good off, trim the picket stake down and bold the door guide (with some packing under it) to the concrete below. I have bolts and a rotary drill that could assist with this. If the above failed I have some alternative heavy duty brackets that could be bolted to the concrete as a substitute. Please note, one issue you'll encounter is how best to cut off the door guide as it sits roughly 40mm from the concrete and my angle grinder couldn't fit under it to cut it off. Oddly, this may be the hard part as once it's off the above approaches should work. Please let me know how you plan to tackle this as I'm open to paying more for welding the guide back into position (just lower) as this will look the nicest. Happy to answer any questions

Punched hole in door. Rough play with kids running in house and closing door

Needing someone to either repair or replace 2 mdf cupboard doors. Currently painted but there are some dents and rough spots that need fixing. Unsure if easier to fix or just replace. No removal or reinstallation needed just the doors. Measurements are 35cmx72cm

Need lock installed in cavity door by Saturday 15/2 12pm

One of the kitchen drawers cannot be open/ close by one push, remaining half open. They are all push to open/ close type. The following items need to be fixed: 1- 1 x tv Cabinet drawer does not close. 2- 1 x Kitchen Draw that will not close. There was 1 opposite that had the faulty slider but it seems to be working for now. However, please check it. 3- End of the TV cabinet needs gluing on it. See photos.

Need a screen door stopper installed on my back screen door

1) assemble outdoor shed 2) patch and paint ceiling holes X2 3) mount 2x clothes line

Replace Inside Panels for Kitchen Sink window which are damaged due to water usage. Looking for alternate replacements

I want to swap the side my front door swings open from. The door is a solid wood door with a lockable handle. There is no dead lock. The cut outs that use to have the hinges should be filled with a wooden shim and wood putty ready for me to paint

handyman work like hang doors and locks, little wall needs plastering, some silicone work and few other things. $50-60 P/h Need it done asap

current garden path way to door is covered with sand, very dirty and messy with weed. Want to replaced with tile (or anything that is cost effective, low maintance and clean so that can use as a walking path. Price above is just estimate. Pending on onsite quote

hole/crack in hollow core door needs repairing

My teenage son did a handstand next to the door and put his foot through the door. We are moving out of the house and need it fixed.

Side door to a garage needs either replacing or some form of repairing. The door is not your standard size, it is 1980mm tall and 810mm wide. It currently appears to have an internal door used that was painted so it would wear through the weather. Happy for the same to be done if it is painted and coated to protect from the weather. Back side of the door seems to be ok. Budget is dependant on if it’s a door replacement or repair. I believe Doors Plus might have a door that can be cut slightly down for it.

Replace the fly screen door

Fly screen door back on hinges

I have a door 200mm x 760mm and I need a glass/plastic viewing window put into it 400mm x 400mm in size. It is an internal door made of wood.