Find an experienced handyman in Newtown

Looking for a carpenter to fix 2 wooden creaky floor boards over a small area. The floorboards are under heshan carpet that cannot be removed. So they will need to drill through heshan.

Install ceiling fan remote control operated ASAP Newtown

move the hinges, scrap door to put the hinges then put screws

Reattach kitchen drawer door (30 mins) Reattach bathroom cupboard door (30 mins) Remove front door handle and install security lock (1 hour) Repair front gate latch (1 hour) Sweep leaves from side of house (30 mins)

I have an arc floor lamp which is no longer working after moving house. I originally wired it myself so it was probably a bit dodgy to start with. I'm not sure if it needs totally rewiring or just the fixture need adjusting. It hasn't been working for a few years now and has been instorage.

We have a pantry unit up against a wall that we want secured with some brackets to stop it tipping. We also have 2 shelf units up against a wall that are currently fixed to prevent tipping that we would like to UN-fix from the wall. Will require screws, brackets and tools. Our walls are solid concrete.

Hi - I need curtain rods installed. Purchased ikea rod and brackets already, just need them drilled in.

Handy man required to help with a few jobs: 1) Patch/paint dent on corner wall 2) Fix male bathroom door (not closing properly) 3) Cut wooded panel/attach to desk to provide privacy . We already have the wooden panel just needs to be cut to size and attached. Work will need to be done next week either Tuesday, Wednesday or Thursday at 7.00am and completed before the clinic opens at 9.00am

Need walls restore to pre-lease condition. I will be removing a number of screws/ hooks , as well as a curtain rod and need the holes filled and painted over. (Probably 30 holes in total)

Need someone to install two doors, i can provide the doors and knobs. Need this done asap. Thank you

Couple of small jobs: - hanging two lightweight canvas portraits (on a brick wall) - screwing in small metal bracket into a timber panel - screwing in door knob (simply screwing out old knob and screwing in the new one)

I need someone to remove a door, plane the bottom of the door to stop it scraping on the floor and then re-hang the door. They may also need to glue the timber veneer back in place as it has come away from the face of the door a little.

Hoping to find an Experienced Professional Handyman for a small job. Could you please provide the Concrete Wall Plugs and bring an Electric Drill. I have included a photo of a pack of ten that could be purchased at Bunnings. They are about $20 for 10. They are 8cm long. I hope this is long enough to be strong to hold some pictures up (2 are heavy and covered in glass). Please make the judgement for the right WallPlugs with casings / anchors etc. They would need to all be from one set and look the same for consistency. I have made the markings in the walls for the whereabouts of the drilling after taking measurements of the picture frames and ropes etc, so it's all ready to go. I have a reliable chair that can be stood on for the job. There are about 6 places marked for 5 pictures and one mirror. I can move the furniture out of the way prior to your arrival. I can pay a flat rate of $160 that would cover the concrete plugs. The day I was hoping to get it done was Friday 26th April. Parking is usually free around here, its a less busy area. I'll check the Offers again tomorrow 20.4.24. Thanks

The double sink in my kitchen has partially fallen from the countertop into the cupboard below.

Need a professional to install 4 ceiling hooks to hang plants. I do not have the hooks. I’d like to hang this planter: https://www.ikea.com/au/en/p/chilistran-hanging-planter-in-outdoor-white-50492260/ It says here that the max load it can hold is 15 kg. Point 1 & 2: not sure (see photos) Point 3 & 4: concrete ceiling Ceiling height is 2.5 m Timber floor Budget not fixed.

Need a wall mount installed https://squareup.com/shop/hardware/au/en/products/kitchen-touchscreen-mount-au

I am looking for an electrician to help me fix two table lamps that have stopped working! One is a vintage Hanimex lamp - may need new bulb or possibly just loose wiring? And the other is a vintage green lamp that uses and adapter. Have attached pictures

Damaged 2 of my rims in 2 spots (each rim). Need an experienced repairer to fix the damage. Preference given if you can fix this today in Newtown.

Hang 3 a0 snap frame posters

I have an iron door to be taken off.