Find an experienced builder in Ringwood North

We have a very, very old above ground pool (Clarks rubber - aluminium) that has been surrounded by a deck that needs to be removed. We need someone with the right tools to demolish and remove ALL of the pool some of it is undercover of deck frame. The part of the deck that was to be removed has mostly been done, some of the deck will remain to be extended. The sand does not need to be removed.

Erect 4.5M by 2.25M pre made shed from easy shed- comes in pre made flat pack package, already on site . Assembling onto concrete slab. Flexible with dates for assembly

Replace rotten timber on end of pergola. I have installed a temporary fix, it needs the end fascia replaced

Small flatpack shed requiring assembly. Timber base built by carpenter and is solid. 3M x 78cm (easyshed - refer picture for exact make/size). Ready to be assembled now.

assemble a garden shed on existing sub floor. 3m x 1.5m x 2.05m - Due date: Flexible

An old timber deck in the back yard need removing and a simple patio with a few steps needs to be built in its place please. - Due date: Flexible

Paint Front Facia of house - pergola and side of house. I have the paint. - Due date: Before Monday, 12 December 2022

fencing and decking brand new - Due date: Flexible

Demolition-and removal of 5 brick piers and a small wall Each pier is approximately 3m x .9 x .25 roughly 240 bricks per pier. The wall is 3.5m x 1.5mt. There is access for small machines 1.8mtr wide. Down side of house. Or couldbe done with wheel barrows. - Due date: Before Thursday, 10th Mar 2022

Looking to build new pergola (5.2M x 7.2M plus 3Mx4M) near swimming pool and deck attached to the Alfresco (6M x 8M).

An area next to driveway that will be needing to be levelled out and a small retaining wall built next to and up to existing fence level so the remaining area can be concreted to butt up next to existing driveway to form a small car parking area. Letter box will need to be removed either by you or we can do in advance of job. - Due date: Flexible

Hi, we are in Ringwood North and have a large Colorbond custom sized shed we need installed that is approx 4.5m wide at front, 12m wide at the rear and goes back around 10m on one side and 6.5m on the other. Height is 2.9m. Materials are all pre-fabricated and ready to go.

Looking for appealing front yard fence thats also affordable with gate for driveway. Havent decided on type of fence. Looking to get a quote.

This is exposed aggregate imitation. put two different colour flecks over the top of a base colour.

I need a draft drawing and engineer designs for my just built verandah and decking without permit. Council sent me a notice to get a certificate of compliance