Find an experienced handyman in Claremont WA

Office Location. Wall concrete so need a proper drill. Have bolts

The awning’s motor appears to be functioning correctly. However there is something faulty with the sensor(s) as the awning will retract randomly when in the open position. I’ve replaced the batteries for the somfy wind sensor, however this didn’t fix the problem. The same sensor appears to have some internal corrosion of circuitry which could be causing the issue. We need someone experienced to check the whole system and provide a fix

Replace a ceiling fan, it’s a DC fan with remote

Hi, I need a handyman to remove the shed from it’s place, prepare the ground for it and move it to the next door wall. Cheers

Our shower is leaking water onto the adjacent bathroom floor because the glass door doesn’t have a rubber seal. We require a handyman to inspect, measure, propose a solution, and complete the task, with no further leaking.

My sunroom has a Perspex ceiling and it is too bright. Looking for simple/cheap solution to make this a study space and theatre room by blocking the light. My first attempt only worked moderately. Room approx 300cm x 550cm.

Carpet minor patching need to be fixed

External Window Decal Installation Dimension: 60cm x 90cm

A few small areas of damage after removing decking and knocking a low wall. Need the damaged areas/ exposed brick seen in the photos plastered.

Looking for a handyman to replace two facia boards & put sealant on the joints of two gutters. For the right person this is a max one hour job. The cost of Facia board which is around $70 will be paid separately.

Our external roller shutter has broken (won't go up). We would like it to be assessed and fixed. Thanks so much

I need help in repairing my blinds that the cord used to adjust the blinds has snapped, and some professional cleaning of the fabric blinds please , so appreciated

2 areas of wall needing repaired by plasterer please. Bathroom ~700x500, Kitchen ~800x700

Bed squeaking and loose so want this fixed please

Install 60 x 18mm bullnose MDF moulding (skirting normally) as a cornice to ceilings. Approximately 40 lineal metres to install into either timber wall plate or brick wall. Timber will be delivered Wednesday morning

I'm a carpenter, moving to Broome, it's been mentioned it would be helpful if I had a little bit of welding experience. Hoping someone can give me an introduction, probably to stick? And MIG? Happy to travel wherever around Perth on a few evenings

Assemble two bed Drill hanger in wall to hang painting and tv

- Mount TV to wall - drill 2 sets of 3m length curtain rods - assist with washing machine set up (can’t figure out plumbing)

I need help with drilling holes and hanging 6 picture frames and a clock in my office. Ideally around 10am if possible please. I have 4 frames that need to be hung at the same height on one wall, 2 at the same height on another wall and the clock on a third wall. Will need to be able to bring own drill, spirit level, wall plugs, screws etc as I have none of this. Thank you !

Need 3x shelves hung on a wall. Have attached a photo of rough size. Wall is sheeted panel, not brick. Handyman with tools and experience required. Thanks