Find an experienced handyman in Gordon NSW

Hello, I would like the following to be hung in our apartment: - 1x large mirror (approx 128cm x 102cm) - 2x large paintings (approx 90cm x 90cm) - 4x small paintings (approx 50cm x 40cm) Thanks

the kitchen sink is loose. need to be mounted properly asap

I have a concrete letterbox that was delivered in 5 pieces and I need help to move and place these pieces in position at the front of my property as they are too heavy for me to handle on my own. I have all the required tools and equipment and the concrete footing is already in place. I imagine this job will take less than an hour.

A cornice piece has come off our bathroom ceiling. We have purchased a replacement piece (approx 4.2m) and need it to be cut to size and installed securely.

Fix the ceciling in bathroom

I have an assembled home gym and need 4 holes (about 18mm diameter) drilled into the metal frame. I also have 2 metal brackets that have a gap for an insert but the gap is a few mm too short. For the gym, I would like the 4 holes to match similar pre-existing holes as a guide. The drilling will need to happen from the side (not above) because the unit is already assembled. The holes will allow the band pegs to be inserted at the specific height (see images as a guide). For the brackets, a the cuts will be like shaving off about 1 or 2mm and only be cut for less than 1cm. This will widen the gap so the insert can be inserted (see image). The unit was made overseas as a bespoke fabrication but the factory got the measurements off slightly.

We just had an electrical awning installed on the roof of our deck. We just need an electrician to connect it to the power. Photos attached.

The 2 ceiling lights need to be removed and replace with the fans with the light

Install a flyscreen for a sliding door. 1 panel only. Height 260cm floor to ceiling, including channel 267cm. Width of screendoor to be 135cm, width of channel to be 267.5cm

Garage door opener needs to be replaced with a new one. Bought a new one from Bunnings (Photos attached)

seal it once i run the internet through

I’ve got a couch that I can’t get in to my lounge, but these are sliding door that needs to be disconnected then I can move the couch in and then put the sliding door back together again. I’m looking for somebody to help me.

The bottom of the blind, where it is linked to the bottom Rail, is dragged off the rail. It need to be fixed. It does not need any new material or blind or rail. It just need to get back to its original position.

Install 3 pcs 1600 each panels 3MM light aluminium panels to front st Facde

Seal a kitchen sink to the benchtop on - Sunday morning - Monday after 6pm - Tuesday after 6pm

Repair a sliding door, was repaired before but keeps coming off the rail

Reinstall a bathroom basin that is about to detach and fall from the wall. - One of the expansion screw is off the wall.

We have Roman blinds in our baby’s bedroom but too much light gets in so she won’t sleep during the day. I got some Veneta Honeycomb Blinds with light guards to sit behind the Romans to block out light. We would like to have someone come and install them. One window is large (2425 x 1600) the other is tiny. (942 x 600mm) Please see attached pictures plus install guides.

The cover of the side mirror of Mazda CX 30 is no longer fitting property as frame is bent

Solid wooden door into side of garage no longer closes and needs to be rehung.