Find an experienced handyman in Lindfield

Provide a quote after site visit and repair due to wear and tear a few tiles fallen off and the bargeboard need fixing to be sealed

Fixing small dents on the wall and repainting it

The seat cover has faded, just need to replace it with new one..

The existing ceiling fan needs replacement

Replace woodwork on the top of the retaining wall. Sides are fine. 9m length, 4 boards wide. Per photos. Remove top woodwork, supply new wood and install. No need to oil, I’ll do that. Thanks

I need five pictures to be hung on walls

Fix/replace short piece of gutter and install a downpipe. See the images. The gutter is less than 1 metre and the downpipe is going to be about 4-5 metres - pls quote to provide supplies and install and paint to match exisiting

The fly screen is coming off the door frame

A sliding door of the wardrobe is not sliding, probably some problem with the wheel? Also a fly screen is coming off the frame.

Repair sunken / uneven driveway

Looking at installing the Stratco Handimate sliding door Shed (HM1).

Fascia to which gutter is attached on one side of our garage has partially rotted causing the gutter to fall away. Fascia will need to be replaced (and painted) and gutter either reattached or replaced. Length is 8-9m. Runs along the side of boundary fence (but just above fence level)so access may be a little awkward but neighbours are friendly so should be able to arrange access across the fence for ease of access if required. Please advise if you need any additional information.

One Roman blind needs new rings and cord

Need to replace 2 window fixed flyscreens upstairs. Approx 86cm x 145 cm

Have an undermount sink that has dropped on one side, needs to be reaffixed to the kitchen counter with suitable adhesive.

Relocate existing plasterboards wall (2.7m high X 5.5m ) approximately 1m in the same room.

Got bit and piece around needing to repair

Pool frameless glass fence, part deck mounted. Hard to close gate. Spigots are old fashioned and plastic wedges(hard to remove) are used to keep frame stable. I would like to change the gate latch and change 2 -4 spigots to the newer ones that are friction fit and tightened with allen screws. Is this something you can do?Thanks

Demolition the current bathrooms and rendering , waterproofing , tiling and installing all of the new fittings. $8000 each

Need a Electrical contractor to run some deck points for me tomorrow. 5 Points only. 25mm Conduit with Orange deck points. Bottom steel done which is easier to run on top.