Find an experienced plumber in The Gap

drain in a brick patio clogged by small roots for probably 2 metres. need a roto rooter or snake device to clear

Task 1- Toilet isn’t filling with water and requires fixing. I attached a photo of the toilet. Task 2- Gas oven requires disconnecting from the kitchen area. Photos attached.

Removal of bathroom basin, fixed with bolts to tiled wall. Fitting of new bathroom cabinet and basin.

In need of a plumber with snake for block drain (tree roots) front of house, access point ORG at back of house. Approx 15-20metres.

Before replacing shower I need to have plumber check for leaks and make sure water proof

My kitchen sink needs to be re-siliconed to the bench.

Neesing to install new mixer tap in kitchen sink

Disconnect shower water connection

Shower base leaking cracked tiles

$500 is not my budget. I need a quote to get warm water into tool shed which is situated under the house with a hot water system in the next room and waste out. Dog wash Also, would like the possibility of a pump to give it more pressure

I have 2 leaky tap washes that need replacing.

Replace the silicon to reseal a kitchen sink in an island bench.

I have 2 leaking taps one in shower and one in bath replaced. I don't know what type etc.

My brick chimney is leaking and I would like a quote to either seal it or have a metal cap place over the entire chimney to stop leaking. thanks

Too big pipe (connection) does not let make the ceiling flash. The connection should be cut (about 10mm) or rearranged.

Hot water timing probleme

I have a Simpson EZI sensor SWF10732 washing machine. The pipe is leaking. I need someone to get it replaced and fitted

Just moved in yesterday and the ensuite toilet is semi blocked. That is waste remains in the toilet but the water seeps through. Address is 22 Parkside crescent, The Gap I am calling for prices, please

Our shower head is leaking

We need a licenced plumber to replace the existing 1/2" copper pipe from the mains with 3/4". The new path is slightly different to the old. See the photo, the new pipe path is drawn on. The connection is at the orange peg in the ground. We want to run up the wall, connect into the hot water system, and then continue on to the tap on the right hand side of the hot water system, where it will connect into the existing cold water 1/2". This means there will be a tap on the 3/4" and the hot water and cold water are both fed by 3/4". We will trench the mains so that it is at the required depth (landscaper on site).