Find a professional local carpenter in Clapham Common

Replacing a rotten wooden doorstep for the back door out into the garden. I would prefer it be replaced with something durable like Sapele then painted white to match the original finish

I’ve got a closet that’s need built in shelves you will have to cut and buy the wood as I don’t have a van to bring the wood back home. I’ll will be paying for all materials.

I need some shelves for an alcove for books - fixing on two brick walls - also a shelf across a radiator on the other wall. Airtasker would need to supply tools and materials.

Seeking removal of wooden stairs and stud wall. Then 2 new wooden steps to be built with a railing. For access

I have a large new stain on my wooden worktop which I would like removed. There are a few other stains too. So if the whole worktop could be sanded and finished with something to prevent similar stains happening again

Take down the shed in my front garden and rebuild in the back garden. Also needs the roof cover reattaching The shed is held together by nails so would need all of them removing as well

Assembly of Ikea platsa wardrobe unit with trim of skirting board with multitool to allow snug fit to wall. Ikea quote for assembly was £75 for reference

The bearings have slipped out and I would like someone knowledgeable to repair. See item here https://www.diy.com/departments/grey-soft-close-lh-corner-cabinet-50cm-pull-out-storage/8010880013030_BQ.prd?storeId=&&&&&gad_source=1&gclid=EAIaIQobChMI6fnYnparhgMVRJVQBh2VjgaTEAQYASABEgIgaPD_BwE&gclsrc=aw.ds

I am having my kitchen worktops replaced with quartz worktops, and in order to do so, the kitchen units need levelling, and some need securing to the wall. The worktop company have just come out with their laser measure to say they cannot measure/fit the worktops as they are at the moment. Kitchen units are an L shape approx 3m x 3m and utility units is one length of 3m. There is some front to back slope and some lengthway slope also. I’m desperate to not have to replace the units, but they need levelling to be within 3mm of level left to right. Laser level likely needed. Let me know if you can help!

Installed a new built in diswasher and I need to install the kitchen cupboard door on top of it now..

I have tried sanding a stain out of a wooden worktop and then oling it and made it a million times worse.

Hi there. You put together some furniture for us and we wondered if you are able to cut, fit some shelving for us with a door attached. This isn’t a flat pack, you would put the shelves up and then fitting a door in front of them to hide them. In addition to this we would like a panel of MDF fitted in the wardrobe for extra storage

The metal bar that holds the top of the table of the electric workstation has bent in the middle so the old screw holes do not align, the ends pieces that hold the table in place have also expanded due to the bend in the middle and we can not slot the 2 metal pieces back in place. This holds up the table top. The legs are fine and are not bent. The electrics of the table works perfectly fine and does not need fixing. * The metal part of the table is hard to bend back- it is very solid - we need someone to put new nails based on the bend of the table and come up with a solution (either making new brackets using wood for the end pieces) so that the table can be put in screwed on. - Due date: Flexible

I need someone to take out the plywood wall and small cupboard door from a small section under my stairs (approx 1.5 m width). Then would like some to make some nice looking storage space/shelving to go under this area of the stairs - no door to go on so would been open and need to look nice and smart - Due date: Flexible

Need the decking in my garden to be taken up. There are some floor lights around the edge that I would like to keep if possible so you would have to be able to cut through some parts accurately as to not damage the fittings Also would be helpful if you are able to dispose of the decking as well - Due date: Flexible

I have a piece of plywood and I have a think tall Ikea bookcase. The floor is uneven so need the plywood cut to the size of the bookcase and placed underneath it. The bookcase is empty - Due date: Before Tuesday, 31 October 2023

*** Amending job*** (1) Put screws in stair threads to help prevent the squeaking. There are 35 stairs but not all squeak. Note there is carpet down which will need to be pulled away and put back roughly. New carpet being laid soon, so only needs to be put back so safe, fine to cut it etc. (2) Knock-down a small built-in wardrobe and put in new skirting. Make wall, floor and edges etc good but no painting required. - Due date: Needs to be done on Sunday, 15 October 2023

My deck needs to be freshened up. I’ll provide the stain, deck wash, broom. You would need to provide the brushes, tray, and a drop cloth. Move the bench which is on the deck inside the house and onto the drop cloth, then wash the deck. Come back on the next sunny day and stain the deck, let it dry then put the furniture back. The deck is 3 square meters. - Due date: Flexible

I have a wardrobe which needs removing that’s built in. I want to replace this with ikea pax wardrobes and do the viral “hack” for built in look. My water tank is currently in wardrobe and would need boxing in with mdf door. Can send pics, drawings and measurements. Happy to discuss budget as getting quotes. - Due date: Before Sunday, 1 October 2023

We have a 200cm wardrobe that we would like to divide into two. Using MDF or similar we would like to insert a floor to ceiling divide inside the wardrobe. On one side inserting a clothes rail (the result being that two rails will exist on that side) The other side attaching expandable shelves. - Due date: Flexible