Find an experienced handyman in Croydon Park NSW

pcb not working need fixing or replacing

Need to replace a rotten beam （about 2m ）in a patio

Need a door installed in our clinic, must have window to be able to view inside room. Needs to be completed within the same day, complete job.

Fix concrete step. Just need it to be concreted together. I can paint over it once it’s set

For our tenants a quote to repair existing loose bi-fold door 70.57cm wide by removing existing track and attachments and supplying and fitting new track and attachments for existing bi-fold door for repair

I have two doors that have holes to be patched up and painted. I have a door that needs to be replaced and also needs to use the same hinges and door knob and needs to be painted as this is a rental property The doors are made with particle board and are hollow.

Quote to Pick up a bi-folding door and sliding track and dispose of door

Render repair required on upstairs window. See photos attached. Job is to repair render on all 4 sides of a single window and leave ready for painting. I initially thought that this job could be completed from inside, but I have not been able to remove both parts of the (sliding) window components. Therefore I now believe the job will need to be completed from the outside with a ladder. Good access from below pathway, however bidder to confirm that there is enough space for safe operation of their ladder.

1. Finish roof for kit carport (all materials provided including ladder). Then connect carport to concrete slab. 2. Provide materials and install guttering for the carport and connect to stormwater downpipe. 3. we need a licensed tradesperson to say that the carport was built according to the instructions

Replace my smeg coffee grinder burr or make my grinder sharp again to effectively grind beans

Two garden sheds assembled

the front yardt tiles are borken，need to fix it.

1. Finish roof for kit carport 2. Provide materials and install guttering for the carport and connect to stormwater downpipe. 3. we need a licensed tradesperson to say that the carport was built according to the instructions

Resurface front verandah and pathway.

I have the new connector but failed to crimp the wires onto the male pins which are inserted into the connector. I don't have the correct square jaw crimp tool for this. I've also never repinned a wire before so not sure 100% if I'm doing it correct...but the abs light never went off when I tried. You will need crimp tool and 2 male pins as per those shown squashed in the photo. There's also 1 left over rubber which I think goes over the pin and wire at the end? You'll need an extra 1 as I broke the other. I'm happy to jack the car up and put on jackstand and take wheel off for you so no labour there...all you got to do is attach to wired to pins and insert to connector and check abs function

There is existing metal hand rail which need to fixed need to connect from brick wall to existing handrail or can replace whole if necessary

Looking for someone to do up our laundry, I’m after: • under/overmount sink. • stone top • shelf or cabinet above (depend on how different the pricing is and we can make it flush with higher cabinet or bulkhead, noting the height of the room is around 2.7m) • room for 1x WM (I don’t think I’ll have space for a dryer. • shelf depending on practicability (see not on the measurement). • bonus if you can do splash back. I can try supply. And also power point if you can. Note: (1) the wall that stick out is a little too short, so a standard backstop / shelf will stick out. I’m wondering if we can add maybe a narrow show shelf there or extend the cabinet door to there (that space will be narrow, and maybe just a space for broom). Something to make the bench that sticks out little eye-soaring. (2) note the other room is a bathroom. So there are a few pipes. I may have some photos from build, so may help. (3) it’s a new house. So I don’t need tiles or anything chances (4) I believe the tile skirting is all around the laundry. So will have a little gap everywhere to fill. I have tried to attach a few inspiration photos, but I’m somewhat flexible noting my budget.

I need a shaving cabinet in my bathroom replaced. Take down from bathroom wall and replace with new cabinet. Dimensions are 75cm× 60cm× 15cm. May need 2 people for installation

I need someone to help remove this wall bracket. Need it done ASAP.

We have a bathroom door that is hard to close and needs to be slightly planed down. Also have a noisy bathroom fan to fix - not sure if the reason