Find an experienced handyman in Watsonia North

Ceiling hole patch and repaint

Small hole in plaster wall need to be fixed

One of my Somfy outdoor blinds came off the rails and has to be fixed. Need help from someone who could help to fix it and service the rest of the other two blinds. Thanks

Hi, I'm need someone to supply and hang & blend a cove cornice. Wall is 2.4m long Would like done asap Care must be taken as new floor is below

My garage door is scraping as it opens and shuts. It used to do this infrequently but now it's happening every time. I believe the arm is worn on 1 side and something is slipping and coming out of alignment, as the door is opening/closing. There is a loud sound as I open/close the door as this bolt appears to move (only on 1 side). I've attached a specific photo of this bolt/arm and general photos. Looking to repair the arm/bolt and create movement without the door scraping.

Cover and plaster over a large holes left from wall heater removal, and very small hole left from aerial (to be removed). Gyprock plasterboard already onsite if needed, as well as a small amount of cement mix but more may be needed. Not required: sanding/painting

Need handyman to fix broken side gate as in the pictures and to replace exhaust fan

Supply and install gold dead lock, gold door knob and also matching gold hinges

Gas stove to be maintained and repaired

Spray wash and brush down of privacy screens. Roller paint and some brush painting work using decking oil on the screens. The oil will need to be applied upto 3 times over a number of days. There are about 29 screens and the length of area would be approximately 30 metres. Would like a good and thorough job.

we have a few blinds where the chains are broken & need fixing, can't lift one of the blinds up

Cabinet protecting electrical switch board has broken as per photos and needs repair or replacement asap.

Small Kings 2kva generator, the revs fluctuate up and down and runs rough. Has less than 10 hours on it but out of warranty, anyone good with small engines and carbys?

14.5" x 14.5 " hole on the wall to be fixed and neatened to fit in the 13.5" x 13.5" panel access plastic board (available) - Due date: Flexible

Hi, I have irrigation installed and the sprinklers are way to big for the area so so much wasted water. 4 sprinklers, need someone to look and replace with suitable sprinklers. Was installed 2 years ago - Due date: Before Saturday, 23 December 2023

Hi..I'm after a renderer ..I can help me take off weather boards so it can be foamed and rendered..I'll also help with insulation and wrap house with paper.you or myself can supply materials ...can pay someone on day rate.. - Due date: Before Wednesday, 27 December 2023

Put cupboard door back on and inbuilt a cupboard. May need some putty to hold screws in place due to existing holes - Due date: Flexible

Need someone to fix the plasterboards in our house, the wall leading to a cupboard under the stairs. Holes are about the size of a fist, maybe a little bigger and they’ve gone straight through the wall to the other side. Not sure about what the price range usually is! I think they’ll have to be repainted and we don’t have the paint for it either! - Due date: Flexible

Kitchen ceiling painting, palstering, caulking door handles fix - Due date: Flexible

Window is not sealed properly against frame when closed. Need assistance with fixing this so noise and wind does not get through. - Due date: Flexible