Find an experienced plumber in Brunswick West

Fresh cut of the sopressa. Very thinly sliced.

I would like to install a dishwasher in my unit and will need it to be plumbed in. I may also need to change the taps to a mixer style. Not sure of cost so feel free to make an offer.

Its been reseated 3 times and had the spindle replaced. After reseating, its fine for a bit and then starts to leak again. Its leaking rate seems to vary, almost as if the flow rate is affected by the other tap (!?). Taps are very stock standard but set behind tiles. This is a job for someone who knows their taps.

New Dishwasher installation (BOSCH Series 6) near the sink, I there is no water inlet so perhaps some plumbing must be done to connect the pipes? I can pay by the hour plus parts of course, or let me know cost See pictures , the one with inlet is the existing, the one be with nothing is the one that needs to be fixed

Washing machine appears to be leaking from the tap area where it fixes to the pipe but it’s screwed on tightly. Need a plumber to look at it/fix.

Need the silicon around a basin and along the kitchen counter redone because it has turned black with mold. I also need the silicon in two showers redone

Booking on half of someone else - need a shower head to be installed. https://www.bunnings.com.au/brasshards-chrome-all-directional-shower-rose-wels-3-star-8l-min_p5004127

The kitchen sink silicone has worn away and water has seeped into our kitchen cabinets underneath over time. This has caused some mould damage. Looking to fix the mould and reseal the kitchen sink.

Need to fix the bathroom sink drain button as it was pushed down and is stuck

I have reseated it 3 times with new washers. Thr problem appears to resolve but thrn it starts leaking again. The taps are only a few years old. Tap is set in behind tiles.

Washing machine drain hose has been leaking from the joint with the sink drain. Need someone to help reattach it without the leak

fix head gasket on 2010 gen 3 prius

I unscrewed the u-pipe to clean it out so the sink would drain better. I’ve reattached it and no matter how firmly I screw it back it won’t stop leaking. Please help. All I need is someone to help screw the pipe back in tightly

Plumber to install new shower head with wall mount handles, new bath spout with wall mount handles and new vanity spout with vanity top mount handles. These are photos of the existing taps that need replacing. We will replace with something similar.

I have a new dishwasher that need to be plumbed to a water source and waste ( under the sink). Updated with photos, dishwasher has been fixed in and requires connection to water source and waste to under the sink. Hose and water might need to be extended.

Our fridge/freezer is on the blink - looking for a professional to come and fix it.

Small toilet base leak and check water draining connection for dish washer

Replace the 20mm elbow as shown in the photo with the same type of elbow with crimped fitting as per detail in side view photo. The elbow is part of copper piping from water tanks that feed toilets and washing machine. The water supply from the tank is currently turned off.

Upstairs toilet in wall cistern is filling really slowly and the toilet is not flushing properly. Now need it looked at today or at latest tomorrow due to work schedule

I need a standard water tap plumbed in to existing piping.